diff --git a/arch/arm/boot/dts/ste-hrefv60plus.dtsi b/arch/arm/boot/dts/ste-hrefv60plus.dtsi
index ecd26848f24f..25b4848e9a6a 100644
--- a/arch/arm/boot/dts/ste-hrefv60plus.dtsi
+++ b/arch/arm/boot/dts/ste-hrefv60plus.dtsi
@@ -102,6 +102,23 @@
 					};
 				 };
 			};
+			mcde {
+				lcd_hrefv60_mode: lcd_hrefv60 {
+					/*
+					 * Display Interface 1 uses GPIO 65 for RST (reset).
+					 * Display Interface 2 uses GPIO 66 for RST (reset).
+					 * Drive DISP1 reset high (not reset), driver DISP2 reset low (reset)
+					 */
+					hrefv60_cfg1 {
+						ste,pins ="GPIO65_F1";
+						ste,config = <&gpio_out_hi>;
+					};
+					hrefv60_cfg2 {
+						ste,pins ="GPIO66_G3";
+						ste,config = <&gpio_out_lo>;
+					};
+				};
+			};
 		};
 	};
 };
diff --git a/arch/arm/mach-ux500/board-mop500-pins.c b/arch/arm/mach-ux500/board-mop500-pins.c
index e208dddfeda9..6cc71d02957f 100644
--- a/arch/arm/mach-ux500/board-mop500-pins.c
+++ b/arch/arm/mach-ux500/board-mop500-pins.c
@@ -308,13 +308,6 @@ static struct pinctrl_map __initdata hrefv60_pinmap[] = {
 	/* Magnetometer uses GPIO 31 and 32, pull these up/down respectively */
 	DB8500_PIN_HOG("GPIO31_V3", gpio_in_pu), /* EN1 */
 	DB8500_PIN_HOG("GPIO32_V2", gpio_in_pd), /* DRDY */
-	/*
-	 * Display Interface 1 uses GPIO 65 for RST (reset).
-	 * Display Interface 2 uses GPIO 66 for RST (reset).
-	 * Drive DISP1 reset high (not reset), driver DISP2 reset low (reset)
-	 */
-	DB8500_PIN_HOG("GPIO65_F1", gpio_out_hi), /* DISP1 NO RST */
-	DB8500_PIN_HOG("GPIO66_G3", gpio_out_lo), /* DISP2 RST */
 	/*
 	 * Touch screen uses GPIO 143 for RST1, GPIO 146 for RST2 and
 	 * GPIO 67 for interrupts. Pull-up the IRQ line and drive both