Is still possible to schedule conn_mon_timer after disassociate from
ieee80211_sta_tx_notify() and ieee80211_offchannel_ps_disable().
Move disassociate check to ieee80211_sta_reset_conn_monitor() to cover
all these cases, and add unlikely since in most the time we call
ieee80211_sta_reset_conn_monitor() when associated.
Signed-off-by: Stanislaw Gruszka <sgruszka@redhat.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
We need to copy this to allow drivers to look
at the information where needed.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
This reverts 4a332a38
("mac80211: Give it some time to do the TSF sync").
There's no point in waiting with a new IBSS merge
just because the hardware hasn't merged up with
the old IBSS yet, and since 34e8f082 we no longer
attempt to merge with the IBSS we're already in.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
The return value of the tx operation is commonly
misused by drivers, leading to errors. All drivers
will drop frames if they fail to TX the frame, and
they must also properly manage the queues (if they
didn't, mac80211 would already warn).
Removing the ability for drivers to return a BUSY
value also allows significant cleanups of the TX
TX handling code in mac80211.
Note that this also fixes a bug in ath9k_htc, the
old "return -1" there was wrong.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Tested-by: Sedat Dilek <sedat.dilek@googlemail.com> [ath5k]
Acked-by: Gertjan van Wingerde <gwingerde@gmail.com> [rt2x00]
Acked-by: Larry Finger <Larry.Finger@lwfinger.net> [b43, rtl8187, rtlwifi]
Acked-by: Luciano Coelho <coelho@ti.com> [wl12xx]
Signed-off-by: John W. Linville <linville@tuxdriver.com>
* Do not fail if the peer supports more or less than 3 algorithms.
* Ignore unknown congestion control algorithms instead of failing.
* Simplify congestion algorithm negotiation (largest is best).
* Do not use a static buffer.
* Fix off-by-two read overflow.
* Avoid extra memory copy (in addition to skb_copy_bits()).
The previous code really made no sense.
Signed-off-by: Rémi Denis-Courmont <remi.denis-courmont@nokia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
sk->sk_state already contains the pipe state.
Signed-off-by: Rémi Denis-Courmont <remi.denis-courmont@nokia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Better document choke skb->cb[] use, like we did in netem and sfb
This adds a compile time check to make sure we dont exhaust skb->cb[]
space.
Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com>
CC: Stephen Hemminger <shemminger@vyatta.com>
CC: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Get rid of debug message that are not useful, and enable
the log messages in case of error.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This is a patch originated with Stefano Salsano and Fabio Ludovici.
It provides several alternative loss models for use with netem.
This patch adds two state machine based loss models.
See: http://netgroup.uniroma2.it/twiki/bin/view.cgi/Main/NetemCLG
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Many users have wanted the old functionality that was lost
to be able to use pfifo as inner qdisc for netem. The reason that
netem could not be classful with the older API was because of the
limitations of the old dequeue/requeue interface; now that qdisc API has
a peek function, there is no longer a problem with using any
inner qdisc's.
This reverts commit 02201464119334690fe209849843881b8e9cfa9f.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Rather than magic constant in code, expose the maximum size of
packet distribution table in API. In iproute2, q_netem defines
MAX_DIST as 16K already.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The netem probability table can be large (up to 64K bytes)
which may be too large to allocate in one contiguous chunk.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Use nla_put_nested to update netlink attribute value.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
lc and wlc use the same formula, but lblc and lblcr use another one. There
is no reason for using two different formulas for the lc variants.
The formula used by lc is used by all the lc variants in this patch.
Signed-off-by: Changli Gao <xiaosuo@gmail.com>
Acked-by: Wensong Zhang <wensong@linux-vs.org>
Signed-off-by: Simon Horman <horms@verge.net.au>
ip_route_newports() is the only place in the entire kernel that
cares about the port members in the routing cache entry's lookup
flow key.
Therefore the only reason we store an entire flow inside of the
struct rtentry is for this one special case.
Rewrite ip_route_newports() such that:
1) The caller passes in the original port values, so we don't need
to use the rth->fl.fl_ip_{s,d}port values to remember them.
2) The lookup flow is constructed by hand instead of being copied
from the routing cache entry's flow.
Signed-off-by: David S. Miller <davem@davemloft.net>
Enhance TIPC to skip unnecessary (and, in some cases, redundant)
preparation work when sending a broadcast link NACK message, since this
preparation is only required for broadcast messages that are sent in a
reliable manner. This change also fixes a bug that caused NACK messages
to be improperly counted as "TX packets" in TIPC's broadcast link
statistics.
Signed-off-by: Allan Stephens <Allan.Stephens@windriver.com>
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
Eliminates support for the "number of requested links" field in a neighbor
discovery message. This field was never used and has been removed from
the TIPC 2.0 protocol specification.
Signed-off-by: Allan Stephens <Allan.Stephens@windriver.com>
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
Eliminates TIPC's prototype support for message sequence numbering
on routable connections (i.e. connections requiring more than one hop).
This capability isn't currently used, and can be removed since TIPC
only supports systems in which all inter-node communication can be
achieved in a single hop.
Signed-off-by: Allan Stephens <Allan.Stephens@windriver.com>
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
Ensure that the routine that starts up processing on a newly created
link endpoint takes the spinlock of the node object that owns the link,
to prevent possible conflicts with processing involving other links
owned by that node object.
Signed-off-by: Allan Stephens <Allan.Stephens@windriver.com>
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
Modifies TIPC's congestion control between a connected port and its
peer so that it works as documented. The following changes have been
made:
1) The counter of the number of messages sent by a port now starts
at zero, rather than one. This prevents the port from reporting port
congestion one message earlier than it was supposed to.
2) The counter of the number of messages sent by a port is now
incremented only if a non-empty message is sent successfully.
This prevents the port from becoming permanently congested if
too many send attempts are unsuccessful because of congestion
(or other reasons). It also removes the risk that empty hand-
shaking messages used during connection setup might cause the
port to report congestion earlier than it was supposed to.
3) The counter of the number of unacknowledged messages received by
a port controlled by an internal TIPC service is now incremented
only if the message is non-empty, in order to be consistent with
the aforementioned changes.
Signed-off-by: Allan Stephens <Allan.Stephens@windriver.com>
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
