* Channel Mode
This is an enum control to change the surround-channel setup,
appears only when the surround channels are available.
It gives the number of channels to be used, "2ch", "4ch" abd "6ch".
According to the configuration, this also controls the
jack-retasking of multi-I/O jacks.
* Independent HP
When this enum control is enabled, the headphone output is routed
from an individual stream (the third PCM such as hw:0,2) instead of
the primary stream.
Signed-off-by: Raymond Yau <superquad.vortex2@gmail.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
In the ugly real world, there area really broken devices that don't set
codec SSID correctly. In such a case, the ID can be random, thus the
patching won't work reliably.
For applying the patch forcibly to such a device, the driver will skip
the vendor and/or subsystem ID checks when zero or a negative number is
given in [codec] section.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Added a new option "snoop" for the traffic control of the HD-audio
controller chip. When set to 0, the non-snooping mode is used with
the traffic control bit is set in each stream control register.
This may allow better operations in the low power mode, but the actual
implementation is depending pretty much on the chipset.
As already implemented, more or less each chipset has own snoop-control
register bit. Now this setup refers to the snoop option, too.
Also, a new VIA chipset may require the non-snooping mode when set so
in BIOS. In such a case, the option value is overridden.
As default, it's still set to snoop=1 for keeping the same behavior as
before. In near future, it'll be set to 0 as default after checking
it works in every system well.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The semantics of snd_mpu401_uart_new()'s interrupt parameters are
somewhat counterintuitive: To prevent the function from allocating its
own interrupt, either the irq number must be invalid, or the irq_flags
parameter must be zero. At the same time, the irq parameter being
invalid specifies that the mpu401 code has to work without an interrupt
allocated by the caller. This implies that, if there is an interrupt
and it is allocated by the caller, the irq parameter must be set to
a valid-looking number which then isn't actually used.
With the removal of IRQF_DISABLED, zero becomes a valid irq_flags value,
which forces us to handle the parameters differently.
This patch introduces a new flag MPU401_INFO_IRQ_HOOK for when the
device interrupt is handled by the caller, and makes the allocation of
the interrupt to depend only on the irq parameter. As suggested by
Takashi, the irq_flags parameter was dropped because, when used, it had
the constant value IRQF_DISABLED.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Introduce the pincfg table to patch_conexant.c for fixing up the extra
pin-configuration for auto-parser. As an example, Lenovo X200 model is
replaced with this new mechanism. (This also fixes the wrong mixer
elements for docking-station I/O in the previous model quirk
automagically.)
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Similarly like ALC662 asus-mode* models, rewrite the laptop-amic and
dmic models with the static pin-config tables.
Now we can get rid of all alc269_quirks.c.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Let's remove the rest of ALC861 and ALC861-VD quirks.
If any breakage is found, it can be fixed easily via the pin-config
table update.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Implement new fixup entries for Quanta FL1 and Fujitsu Lifebook
specific COEF and pin configurations. Removed the model entries
from alc269_quirks.c.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
ALC260 HP models work with the BIOS auto-parser. Let's cut them off.
Also move alc260_hp_master_*() to alc262_quirks.c as these are still
referred from there.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Patch reviewers now recommend not splitting long user-visible strings,
such as printk messages, even if they exceed 80 columns. This avoids
breaking grep. However, that recommendation did not actually appear
anywhere in Documentation/CodingStyle.
See, for example, the thread at
http://news.gmane.org/find-root.php?message_id=%3c1312215262.11635.15.camel%40Joe%2dLaptop%3e
Signed-off-by: Josh Triplett <josh@joshtriplett.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Currently the use of pm_runtime_put_sync() is not safe from
interrupts-disabled context because rpm_idle() will release the
spinlock and enable interrupts for the idle callbacks. This enables
interrupts during a time where interrupts were expected to be
disabled, and can have strange side effects on drivers that expected
interrupts to be disabled.
This is not a bug since the documentation clearly states that only
_put_sync_suspend() is safe in IRQ-safe mode.
However, pm_runtime_put_sync() could be made safe when in IRQ-safe
mode by releasing the spinlock but not re-enabling interrupts, which
is what this patch aims to do.
Problem was found when using some buggy drivers that set
pm_runtime_irq_safe() and used _put_sync() in interrupts-disabled
context.
Reported-by: Colin Cross <ccross@google.com>
Tested-by: Nishanth Menon <nm@ti.com>
Signed-off-by: Kevin Hilman <khilman@ti.com>
Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Create /sys/devices/platform/ideapad/cfg for showing cfg value.
Signed-off-by: Ike Panhc <ike.pan@canonical.com>
Signed-off-by: Matthew Garrett <mjg@redhat.com>
we can now autodetect internal 3G device and already have the threeg
rfkill device. So, we plan to remove threeg sysfs support for it's no
longer necessary.
We also plan to remove interface sysfs file that exposed which ACPI-WMI
interface that was used by acer-wmi driver. It will replaced by information
log when acer-wmi initial.
We keep it around for userspace compatibility reasons, schedule removal
in 2012.
Cc: Carlos Corbacho <carlos@strangeworlds.co.uk>
Cc: Matthew Garrett <mjg@redhat.com>
Cc: Dmitry Torokhov <dtor@mail.ru>
Cc: Corentin Chary <corentincj@iksaif.net>
Acked-by: Thomas Renninger <trenn@suse.de>
Signed-off-by: Lee, Chun-Yi <jlee@novell.com>
Signed-off-by: Matthew Garrett <mjg@redhat.com>
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (54 commits)
ipv6: check for IPv4 mapped addresses when connecting IPv6 sockets
mlx4: decreasing ref count when removing mac
net: Fix security_socket_sendmsg() bypass problem.
net: Cap number of elements for sendmmsg
net: sendmmsg should only return an error if no messages were sent
ixgbe: fix PHY link setup for 82599
ixgbe: fix __ixgbe_notify_dca() bail out code
igb: fix WOL on second port of i350 device
e1000e: minor re-order of #include files
e1000e: remove unnecessary check for NULL pointer
intel drivers: repair missing flush operations
macb: restore wrap bit when performing underrun cleanup
cdc_ncm: fix endianness problem.
irda: use PCI_VENDOR_ID_*
mlx4: Fixing Ethernet unicast packet steering
net: fix NULL dereferences in check_peer_redir()
bnx2x: Clear MDIO access warning during first driver load
bnx2x: Fix BCM578xx MAC test
bnx2x: Fix BCM54618se invalid link indication
bnx2x: Fix BCM84833 link
...
Add new parameter to disable rounding of buffer/period sizes to
multiples of 128 bytes. This is more efficient in terms of memory
access but isn't required by the HDA spec and prevents users from
specifying exact period/buffer sizes. For example for 44.1kHz, a
period size set to 20ms will be rounded to 19.59ms.
Tested and enabled on Intel HDA controllers. Option is disabled by
default for other controllers.
Tested-by: Wu Fengguang <fengguang.wu@intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
