Only supported on NV50+ so far, and disabled by default currently. The
module parameter "msi=1" will enable it.
There's a kernel bug which will cause this to fail if the module (or the
NVIDIA binary driver) has ever been loaded before loading nouveau with
MSI enabled. As such, this is only safe to enable if you have nouveau
load on boot, and don't wish to ever reload it.
The workaround is to "echo 0 > /sys/bus/pci/devices/<device>/enable"
until the enable count reads 0. Then you should be able to load nouveau
with MSI enabled.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
We previously added all the available classes for the entire generation,
even though the objects wouldn't work on the hardware.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The old code generated an interrupt storm bad enough to completely
take down my system.
Signed-off-by: Andy Lutomirski <luto@mit.edu>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Remove some unused/duplicated definitions and make sparse happy again.
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
There are two messages in the ISR of nouveau which might be printed out
hundred times in a second. Ratelimit them. (We need to move
nouveau_ratelimit to the top of the file.)
Signed-off-by: Jiri Slaby <jslaby@suse.cz>
Reviewed-by: Marcin Slusarz <marcin.slusarz@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The most important part of this change is that we now instruct PFIFO to
drop all pending fetches, rather than attempting to skip a single dword
and hope that things would magically sort themselves out - they usually
don't, and we end up with PFIFO being completely hung.
This commit also adds somewhat more useful logging when these exceptions
occur.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Leaving the IRQ unack'ed while switching contexts makes the switch
fail randomly on some nv1x.
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
* drm-fbdev-cleanup:
drm/fb: remove drm_fb_helper_setcolreg
drm/kms/fb: use slow work mechanism for normal hotplug also.
drm/kms/fb: add polling support for when nothing is connected.
drm/kms/fb: provide a 1024x768 fbcon if no outputs found.
drm/kms/fb: separate fbdev connector list from core drm connectors
drm/kms/fb: move to using fb helper crtc grouping instead of core crtc list
drm/fb: fix fbdev object model + cleanup properly.
Conflicts:
drivers/gpu/drm/i915/i915_drv.h
drivers/gpu/drm/nouveau/nouveau_drv.h
The fbdev layer in the kms code should act like a consumer of the kms services and avoid having relying on information being store in the kms core structures in order for it to work.
This patch
a) removes the info pointer/psuedo palette from the core drm_framebuffer structure and moves it to the fbdev helper layer, it also removes the core drm keeping a list of kernel kms fbdevs.
b) migrated all the fb helper functions out of the crtc helper file into the fb helper file.
c) pushed the fb probing/hotplug control into the driver
d) makes the surface sizes into a structure for ease of passing
This changes the intel/radeon/nouveau drivers to use the new helper.
Signed-off-by: Dave Airlie <airlied@redhat.com>
This makes nouveau recognise and report more kinds of PGRAPH errors, as
well as prevent GPU lockups resulting from some of them.
Lots of guesswork was involved and some part of this is probably
incorrect. Some potential-lockuop situations are handled by just
resetting a whole PGRAPH subunit, which doesn't sound like a "proper"
solution, but seems to work just fine... for now.
Signed-off-by: Marcin Kościelnicki <koriakin@0x04.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The nv50 pgraph handler (for example) could reenable pgraph fifo access
and that would be bad when pgraph context is being unloaded (we need the
guarantee a ctxprog isn't running).
Signed-off-by: Maarten Maathuis <madman2003@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Unset the bit that indicates that a ctxprog can continue at the end.
Signed-off-by: Maarten Maathuis <madman2003@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Apparently, they generate a PFIFO interrupt each time one of the
semaphore methods is executed if its ctxdma wasn't manually marked as
valid. This patch makes it flip the valid bit in response to the
DMA_SEMAPHORE method (which triggers the IRQ even for a valid ctxdma).
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Currently Nouveau is unable to dismiss DMA_VTX_PROTECTION errors,
which results in an infinite loop in the interrupt handler.
These errors are caused both by bugs in the Gallium driver and by
user-specified index buffers with out of bounds indices.
By mmio-tracing the nVidia drivers, I found out how this is done.
On DMA_VTX_PROTECTION, The nVidia driver reads the register 0x402000,
always getting the value 4, and then writes 4 back to 0x402000.
This patch adds that logic by reading 0x402000 and writing the same
value back.
It's unclear what should happen if the value read is not 4, and
the current approach might not be the correct one.
To test this, modify mesa/progs/trivial/vbo-drawrange.c, defining
ELTOBJ to 1 and replacing indices with huge out of bounds integers.
Without this patch, the GPU and/or kernel should lock up.
With this patch, it should misrender as expected but not lock up.
The errors are still logged since they are useful for development.
This has been tested on NV49 and may not work on other cards.
To find out how things work on other cards, run the aforementioned
test using the blob with mmiotrace and grep for a read of the PGRAPH
source register.
Signed-off-by: Luca Barbieri <luca@luca-barbieri.com>
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The below is mainly an educated guess at what's going on, docs would
sure be handy... NVIDIA? :P
It appears it's possible for a ctxprog to run even while a GPU exception
is pending. The GF8 and up ctxprogs appear to have a small snippet of
code which detects this, and stalls the ctxprog until it's been handled,
which essentially looks like:
if (r2 & 0x00008000) {
r0 |= 0x80000000;
while (r0 & 0x80000000) {}
}
I don't know of any way that flag would get cleared unless the driver
intervenes (and indeed, in the cases I've seen the hang, nothing steps
in to automagically clear it for us). This patch causes the driver to
clear the flag during the PGRAPH IRQ handler.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
This adds a drm/kms staging non-API stable driver for GPUs from NVIDIA.
This driver is a KMS-based driver and requires a compatible nouveau
userspace libdrm and nouveau X.org driver.
This driver requires firmware files not available in this kernel tree,
interested parties can find them via the nouveau project git archive.
This driver is reverse engineered, and is in no way supported by nVidia.
Support for nearly the complete range of nvidia hw from nv04->g80 (nv50)
is available, and the kms driver should support driving nearly all
output types (displayport is under development still) along with supporting
suspend/resume.
This work is all from the upstream nouveau project found at
nouveau.freedesktop.org.
The original authors list from nouveau git tree is:
Anssi Hannula <anssi.hannula@iki.fi>
Ben Skeggs <bskeggs@redhat.com>
Francisco Jerez <currojerez@riseup.net>
Maarten Maathuis <madman2003@gmail.com>
Marcin Kościelnicki <koriakin@0x04.net>
Matthew Garrett <mjg@redhat.com>
Matt Parnell <mparnell@gmail.com>
Patrice Mandin <patmandin@gmail.com>
Pekka Paalanen <pq@iki.fi>
Xavier Chantry <shiningxc@gmail.com>
along with project founder Stephane Marchesin <marchesin@icps.u-strasbg.fr>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>
