On codec chips with both audio and modem functions (e.g. Conexant one),
performing AC97_RESET resets the whole registers. When both audio and
modem drivers are resumed at the same time, the modem one often is
resumed after the audio, and it results in the reset of audio registers
(ALSA bug#3333).
This patch fixes such a problem. Since the modem codec basically
doesn't need AC97_RESET, skip this initialization unless specified
as audio.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Replace the direct calculation of jiffies with msecs_to_jiffies().
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Include ac97_patch.c from the main ac97_codec.c in order to make
bunch of patch_*() functions static. This helps optimization.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Fixed the silent output problem on laptops with Conexant Cx20551 codec
chip, such as Packard-bell EasyNote A* series.
The information was taken from ALSA bug#1134.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Remove delayed work properly at free and suspend in ac97 codec and
ak4114 drivers.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Mark TLV data as 'const'
Signed-of-by: Philipp Matthias Hahn <pmhahn@pmhahn.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Previously, ac97_codec.c was coded to support AD1986 and AD1986A
CODECs using code written for the AD1985 CODEC. This allowed the
LINE_OUT and HEADPHONE jacks to function properly, however register
differences between the CODECs prevented line and microphone inputs
from functioning.
Specifically, this patch fixes issues with the following mixer
controls: 'V_REFOUT', 'Spread Front to Surround and Center/LFE',
'Exchange Front/Surround', 'Surround Jack Mode', and 'Channel Mode'.
This patch removes the undocumented AD1888 control
'High Pass Filter Enable' and adds the new control
'Exchange Mic/Line In'.
Signed-off-by: Randy Cushman <rcushman_linux@earthlink.net>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Don't enable power-saving mode on drivers that don't support
it. The supporting drivers set AC97_SCAP_POWER_SAVE to scaps
at creation of ac97 instance.
Currently enable on the following drivers: intel8x0, intel8x0m,
atiixp, atiixp-modem, via82xx and via82xx-modem.
Also, a bit clean up of power-saving stuff:
- Don't create an own workq
- Remove superfluous ifdefs
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
This patch fixes a couple of bit update functions in
alsa-kernel/pci/ac97/ac97_codec.c, which could possibly corrupt bits not
in the given mask.
Specifically, it'll clobber unset bits in the target that are not in the
mask, when the corresponding bit in the given new value is set.
Signed-off-by: James C Georgas <jgeorgas@rogers.com>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Fix the bug in AC97 power-saving mode that the power isn't turned on
when power_save is set to 1 via sysfs during the power off state.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
The attached patch will force building the S/PDIF controls on the PCU
SSID for Asus P5P800-VM motherboard, even if the AC97_EI_SPDIF bit is
not set.
Signed-off-by: Magnus Sandin <magnus@sandin.cx>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Added the TLV support to AC97 codec driver for addition of
dB range information.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
This patch adds some codec-specific controls for Philips UCB1400 codec.
Signed-off-by: Mike Rapoport <mike@compulab.co.il>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Added CONFIG_SND_AC97_POWER_SAVE kernel config to enable the support
of aggressive AC97 power-saving mode. In this mode, the AC97
powerdown register bits are dynamically controlled at each open/close
of PCM streams.
The mode is activated via power_save option for snd-ac97-codec
driver. As default it's off. It can be turned on/off on the fly
via sysfs, too.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Orignally proposed by Sam Revitch <sam.revitch@gmail.com>.
Unregister device files at disconnection to avoid the futher accesses.
Also, the dev_unregister callback is removed and replaced with the
combination of disconnect + free.
A new function snd_card_free_when_closed() is introduced, which is
used in USB disconnect callback.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Revert the mixer element names of some Mic controls to the state of
2.6.17. This should fix the name mismatch in alsactl.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Cc: Jaroslav Kysela <perex@suse.cz>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
This patch by Rodolfo Giometti disables the AC97 AUX and VIDEO controls
on the WM9705 when the touchscreen is selected as the AUX and VIDEO
lines are shared with the touch controller.
Changes:-
o Added AC97_HAS_NO_AUX flag
o Test for AC97_HAS_NO_AUX flag in snd_ac97_mixer_build()
o Sets AC97_HAS_NO_VIDEO and AC97_HAS_NO_AUX in patch_wolfson05() when
WM9705 touch driver is selected.
Signed-off-by: Rodolfo Giometti <giometti@linux.it>
Signed-off-by: Liam Girdwood <liam.girdwood@wolfsonmicro.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
This patch conditions AC97 control creation by whether or not the
codec is an AD18xx codec. This fixes the case where the default control
would get created and then snd_ac97_mixer_build fails out when creation
of ad18xx specific control would get attempted. This problem was found
and debuged by Marcelo Tosatti.
Signed-off-by: Jaya Kumar <jayakumar.alsa@gmail.com>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Modules: AC97 Codec
Add the pointer to a static volume resolution table to ac97 template,
so that the drivers can define the volume resolution, too.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Modules: AC97 Codec
Added the support of static resolution table support for codecs
that the driver cannot probe the volume resolution properly.
The table pointer should be set in each codec patch.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Semaphore to mutex conversion.
The conversion was generated via scripts, and the result was validated
automatically via a script as well.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Modules: AC97 Codec,ATIIXP driver,Intel8x0 driver
This patch adds a new quirk for ac97 hardware that combines the existing
AC97_TUNE_MUTE_LED and AC97_TUNE_HP_ONLY quirks. This is needed for several
current HP laptops. Additionally, it adds the HP nx6125 to the
AC97_TUNE_MUTE_LED list.
Fixed for the latest version of ALSA by Takashi Iwai <tiwai@suse.de>.
Signed-off-by: Matthew Garrett <mjg59@srcf.ucam.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Modules: AC97 Codec
Small fix for ALC65x codec, sync with Realtek's driver codes:
- Rename 'IEC958 Playback Route' to 'IEC958 Playback Source' so that
mixer can handle it properly
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Modules: AC97 Codec
Add NULL check in snd_ac97_suspend() and snd_ac97_resume() so that
the caller doesn't have to do it by itself.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Modules: AC97 Codec
Generate a better name string for ac97_bus sysfs interface including
the name of ac97 codec chip.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Use schedule_timeout_{,un}interruptible() instead of
set_current_state()/schedule_timeout() to reduce kernel size. Also use
human-time conversion functions instead of hard-coded division to avoid
rounding issues.
Signed-off-by: Nishanth Aravamudan <nacc@us.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Remove snd_runtime_check() macro.
This macro worsens the readability of codes. They should be either
normal if() or removable asserts.
Also, the assert displays stack-dump, instead of only the last caller
pointer.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
This patch cleans last ac97 audio/modem codec interception in
initialization procedures (ac97_mixer_new()) and removes obsolete
SHARED_TYPE 'locking' which prevents from AMC codecs to function
correctly.
Signed-off-by: Sasha Khapyorsky <sashak@smlink.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
AC97 Codec
Don't use dev.platform_data to store a reference to the containing
ac97_t structure. Such assignment is redundent since we can deduce the
ac97_t structure location from the contained device structure. This
sets platform_data free for other purposes.
Signed-off-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
AC97 Codec
Fix the internal speaker problem (e.g. Targa Traveller 826)
with ALC658D codec. The info is taken from Cyberlink/realtek-modified code.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
AC97 Codec
The patch fixes the bus_id conflict error when registering two codecs
of the same type (ALSA bug#1334).
Signed-off-by: Bjorge Dijkstra <bjorge@gmx.net>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
AC97 Codec,PCI drivers
I've made the review changes and as requested I've pasted the RFC by
Nicolas below:-
'I would like to know what people think of the following patch. It
allows for a codec on an AC97 bus to be shared with other drivers which
are completely unrelated to audio. It registers a new bus type, and
whenever a codec instance is created then a device for it is also
registered with the driver model using that bus type. This allows, for
example, to use the extra features of the UCB1400 like the touchscreen
interface and the additional GPIOs and ADCs available on that chip for
battery monitoring. I have a working UCB1400 touchscreen driver here
that simply registers with the driver model happily working alongside
with audio features using this.'
Changes over RFC:-
o Now matches codec name within codec group.
o Added ac97_dev_release() to stop kernel complaining about no release
method for device.
o Added 'config SND_AC97_BUS' to sound/pci/Kconfig and moved 'config
SND_AC97_CODEC' out with the PCI=n statement.
o module is now called snd-ac97-bus
Signed-off-by: Liam Girdwood <liam.girdwood@wolfsonmicro.com>
Signed-off-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
AC97 Codec
o Enhanced current WM97xx support to provide additional controls and
use the kcontrol suffix naming convention.
o Added AC97_HAS_NO_MIC, AC97_HAS_NO_TONE and AC97_HAS_NO_STD_PCM.
o Cleaned up WM97xx related comments.
o Removed some wm9713 double mono controls and replaced with stereo
controls.
Signed-off-by: Liam Girdwood <liam.girdwood@wolfsonmicro.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
