mirror of
https://github.com/FEX-Emu/linux.git
synced 2024-12-26 11:28:28 +00:00
289b7bfd48
Core fixes:
- Defer GPIO device setup until after gpiolib is initialized.
It turns out that a few very tightly integrated GPIO platform
drivers initialize so early (befor core_initcall()) so that
the gpiolib isn't even initialized itself. That limits what
the library can do, and we cannot reference uninitialized
fields until later. Defer some of the initialization until
right after the gpiolib is initialized in these (rare) cases.
- As a consequence: do not use devm_* resources when allocating
the states in the initial set-up of the gpiochip.
Driver fixes:
- In ACPI retrieveal: ignore GpioInt when looking for output
GPIOs.
- Fix legacy builds on the PXA without a backing pin controller.
- Use correct datatype on pca953x register writes.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1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=X4YD
-----END PGP SIGNATURE-----
Merge tag 'gpio-v4.6-3' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio
Pull GPIO fixes from Linus Walleij:
"Here is a set of four GPIO fixes. The two fixes to the core are
serious as they are regressing minor architectures.
Core fixes:
- Defer GPIO device setup until after gpiolib is initialized.
It turns out that a few very tightly integrated GPIO platform
drivers initialize so early (befor core_initcall()) so that the
gpiolib isn't even initialized itself. That limits what the
library can do, and we cannot reference uninitialized fields until
later.
Defer some of the initialization until right after the gpiolib is
initialized in these (rare) cases.
- As a consequence: do not use devm_* resources when allocating the
states in the initial set-up of the gpiochip.
Driver fixes:
- In ACPI retrieveal: ignore GpioInt when looking for output GPIOs.
- Fix legacy builds on the PXA without a backing pin controller.
- Use correct datatype on pca953x register writes"
* tag 'gpio-v4.6-3' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio:
gpio: pca953x: Use correct u16 value for register word write
gpiolib: Defer gpio device setup until after gpiolib initialization
gpiolib: Do not use devm functions when registering gpio chip
gpio: pxa: fix legacy non pinctrl aware builds
gpio / ACPI: ignore GpioInt() GPIOs when requesting GPIO_OUT_*
|
||
|---|---|---|
| .. | ||
| accessibility | ||
| acpi | ||
| amba | ||
| android | ||
| ata | ||
| atm | ||
| auxdisplay | ||
| base | ||
| bcma | ||
| block | ||
| bluetooth | ||
| bus | ||
| cdrom | ||
| char | ||
| clk | ||
| clocksource | ||
| connector | ||
| cpufreq | ||
| cpuidle | ||
| crypto | ||
| dca | ||
| devfreq | ||
| dio | ||
| dma | ||
| dma-buf | ||
| edac | ||
| eisa | ||
| extcon | ||
| firewire | ||
| firmware | ||
| fmc | ||
| fpga | ||
| gpio | ||
| gpu | ||
| hid | ||
| hsi | ||
| hv | ||
| hwmon | ||
| hwspinlock | ||
| hwtracing | ||
| i2c | ||
| ide | ||
| idle | ||
| iio | ||
| infiniband | ||
| input | ||
| iommu | ||
| ipack | ||
| irqchip | ||
| isdn | ||
| leds | ||
| lguest | ||
| lightnvm | ||
| macintosh | ||
| mailbox | ||
| mcb | ||
| md | ||
| media | ||
| memory | ||
| memstick | ||
| message | ||
| mfd | ||
| misc | ||
| mmc | ||
| mtd | ||
| net | ||
| nfc | ||
| ntb | ||
| nubus | ||
| nvdimm | ||
| nvme | ||
| nvmem | ||
| of | ||
| oprofile | ||
| parisc | ||
| parport | ||
| pci | ||
| pcmcia | ||
| perf | ||
| phy | ||
| pinctrl | ||
| platform | ||
| pnp | ||
| power | ||
| powercap | ||
| pps | ||
| ps3 | ||
| ptp | ||
| pwm | ||
| rapidio | ||
| ras | ||
| regulator | ||
| remoteproc | ||
| reset | ||
| rpmsg | ||
| rtc | ||
| s390 | ||
| sbus | ||
| scsi | ||
| sfi | ||
| sh | ||
| sn | ||
| soc | ||
| spi | ||
| spmi | ||
| ssb | ||
| staging | ||
| target | ||
| tc | ||
| thermal | ||
| thunderbolt | ||
| tty | ||
| uio | ||
| usb | ||
| uwb | ||
| vfio | ||
| vhost | ||
| video | ||
| virt | ||
| virtio | ||
| vlynq | ||
| vme | ||
| w1 | ||
| watchdog | ||
| xen | ||
| zorro | ||
| Kconfig | ||
| Makefile | ||