Johan Rudholm 2d079c43bc mmc: core: consistent handling of initial values ... mmc_do_hw_reset(), mmc_power_up() and mmc_power_off() all set similar initial values for bus_mode, bus_width, chip_select and timing. Let's make this handling simpler and more consistent by sticking them together in a common function. This will introduce small changes in behavior in the following places: mmc_power_off(): For SPI hosts, explicitly set bus_mode = MMC_BUSMODE_PUSHPULL and chip_select = MMC_CS_HIGH, before we left them as they were. For non-SPI hosts, set bus_mode = MMC_BUSMODE_PUSHPULL instead of MMC_BUSMODE_OPENDRAIN as before. These two changes should not be a problem since the device will be powered off anyway. mmc_do_hw_reset(): Always set bus_mode = MMC_BUSMODE_PUSHPULL, as required by SD/SDIO cards. MMC cards require MMC_BUSMODE_OPENDRAIN, but this is taken care of by mmc_init_card() and mmc_attach_mmc(). Signed-off-by: Johan Rudholm <johanru@axis.com> Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>		2014-11-26 14:30:57 +01:00
..
card	mmc: mmc_test: Extend "Badly aligned" tests for 8-byte alignment	2014-11-10 12:40:54 +01:00
core	mmc: core: consistent handling of initial values	2014-11-26 14:30:57 +01:00
host	mmc: omap_hsmmc: remove unused slot_id parameter	2014-11-26 14:30:56 +01:00
Kconfig
Makefile