linux/drivers
Icenowy Zheng 3ecc25e12f phy: sun4i-usb: support automatically switch PHY0 route to MUSB/HCI
On newer Allwinner SoCs (H3 and after), the PHY0 node is routed to both
MUSB controller for peripheral and host support (the host support is
slightly broken), and a pair of EHCI/OHCI controllers, which provide a
better support for host mode.

Add support for automatically switch the route of PHY0 according to the
status of dr_mode and id det pin.

Only H3 have this function enabled in this patch, as further SoCs will
be tested later and then have it enabled.

As H5 is reusing the PHY driver of H3, this function is also enabled.

Signed-off-by: Icenowy Zheng <icenowy@aosc.xyz>
Acked-by: Chen-Yu Tsai <wens@csie.org>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
2017-04-10 16:42:58 +05:30
..
accessibility
acpi
amba
android
ata
atm
auxdisplay
base
bcma
block
bluetooth
bus
cdrom
char
clk
clocksource
connector
cpufreq
cpuidle
crypto
dax
dca
devfreq
dio
dma
dma-buf
edac
eisa
extcon
firewire
firmware
fmc
fpga
fsi
gpio
gpu
hid
hsi
hv
hwmon
hwspinlock
hwtracing
i2c
ide
idle
iio
infiniband
input
iommu
ipack
irqchip
isdn
leds
lguest
lightnvm
macintosh
mailbox
mcb
md
media
memory
memstick
message
mfd mfd: exynos-lpass: Use common soc/exynos-regs-pmu.h header 2017-04-10 16:42:57 +05:30
misc
mmc
mtd
net
nfc
ntb
nubus
nvdimm
nvme
nvmem
of
oprofile
parisc
parport
pci
pcmcia
perf
phy phy: sun4i-usb: support automatically switch PHY0 route to MUSB/HCI 2017-04-10 16:42:58 +05:30
pinctrl
platform
pnp
power
powercap
pps
ps3
ptp
pwm
rapidio
ras
regulator
remoteproc
reset
rpmsg
rtc
s390
sbus
scsi
sfi
sh
sn
soc
spi
spmi
ssb
staging
target
tc
thermal
thunderbolt
tty
uio
usb
uwb
vfio
vhost
video
virt
virtio
vlynq
vme
w1
watchdog
xen
zorro
Kconfig
Makefile