mirror of
https://github.com/FEX-Emu/linux.git
synced 2024-12-24 02:18:54 +00:00
4fa0043731
Handling HT configuration changes involved setting the channel with the new HT parameters and then issuing a rate_update() notification to the driver. This behavior changed after the off-channel changes. Now, the channel is not updated with the new HT params in enable_ht() - instead, it is now done when the scan work terminates. This results in the driver depending on stale information, defaulting to non-HT mode always. Fix this by passing the new channel type to the driver. Cc: stable@kernel.org Signed-off-by: Sujith <Sujith.Manoharan@atheros.com> Signed-off-by: John W. Linville <linville@tuxdriver.com> |
||
---|---|---|
.. | ||
aes_ccm.c | ||
aes_ccm.h | ||
aes_cmac.c | ||
aes_cmac.h | ||
agg-rx.c | ||
agg-tx.c | ||
cfg.c | ||
cfg.h | ||
debugfs_key.c | ||
debugfs_key.h | ||
debugfs_netdev.c | ||
debugfs_netdev.h | ||
debugfs_sta.c | ||
debugfs_sta.h | ||
debugfs.c | ||
debugfs.h | ||
driver-ops.h | ||
driver-trace.c | ||
driver-trace.h | ||
event.c | ||
ht.c | ||
ibss.c | ||
ieee80211_i.h | ||
iface.c | ||
Kconfig | ||
key.c | ||
key.h | ||
led.c | ||
led.h | ||
main.c | ||
Makefile | ||
mesh_hwmp.c | ||
mesh_pathtbl.c | ||
mesh_plink.c | ||
mesh.c | ||
mesh.h | ||
michael.c | ||
michael.h | ||
mlme.c | ||
offchannel.c | ||
pm.c | ||
rate.c | ||
rate.h | ||
rc80211_minstrel_debugfs.c | ||
rc80211_minstrel.c | ||
rc80211_minstrel.h | ||
rc80211_pid_algo.c | ||
rc80211_pid_debugfs.c | ||
rc80211_pid.h | ||
rx.c | ||
scan.c | ||
spectmgmt.c | ||
sta_info.c | ||
sta_info.h | ||
status.c | ||
tkip.c | ||
tkip.h | ||
tx.c | ||
util.c | ||
wep.c | ||
wep.h | ||
wme.c | ||
wme.h | ||
work.c | ||
wpa.c | ||
wpa.h |