Maarten ter Huurne ea3952e01c MIPS: JZ4740: reset: Initialize hibernate wakeup counters. ... In hibernation mode only the wakeup logic and the RTC are left running, so this is what users perceive as power down. If the counters are not initialized, the corresponding pin (typically connected to the power button) has to be asserted for two seconds before the device wakes up. Most users expect a shorter wakeup time. I took the timing values of 100 ms and 60 ms from BouKiCHi's patch for the Dingoo A320 kernel. Signed-off-by: Maarten ter Huurne <maarten@treewalker.org> Cc: Sergei Shtylyov <sshtylyov@mvista.com> Cc: Lars-Peter Clausen <lars@metafoo.de> Cc: linux-mips@linux-mips.org Patchwork: https://patchwork.linux-mips.org/patch/3563/ Signed-off-by: Ralf Baechle <ralf@linux-mips.org>		2012-07-23 13:56:20 +01:00
..
board-qi_lb60.c	MIPS: JZ4740: qi_lb60: Look for NAND chip in bank 1.	2012-07-23 13:56:20 +01:00
clock-debugfs.c
clock.c
clock.h
dma.c
gpio.c	MIPS: JZ4740: GPIO: Check correct IRQ in demux handler	2011-10-24 23:34:25 +01:00
irq.c	MIPS: JZ4740: Use generic irq chip	2011-10-24 23:34:25 +01:00
irq.h	MIPS: JZ4740: Use generic irq chip	2011-10-24 23:34:25 +01:00
Kconfig
Makefile	MIPS: Remove all -Wall and almost all -Werror usage from arch/mips.	2012-05-21 15:09:36 +01:00
Platform
platform.c	MTD: NAND: JZ4740: Multi-bank support with autodetection	2012-07-23 13:56:20 +01:00
pm.c	MIPS: JZ4740: Use generic irq chip	2011-10-24 23:34:25 +01:00
prom.c
pwm.c
reset.c	MIPS: JZ4740: reset: Initialize hibernate wakeup counters.	2012-07-23 13:56:20 +01:00
reset.h
serial.c
serial.h
setup.c
time.c	Merge branch 'timers-clocksource-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip	2011-05-19 17:44:13 -07:00
timer.c
timer.h