Florian Fainelli b2f2af21e3 net: dsa: allow enabling and disable switch ports ...

Whenever a per-port network device is used/unused, invoke the switch
driver port_enable/port_disable callbacks to allow saving as much power
as possible by disabling unused parts of the switch (RX/TX logic, memory
arrays, PHYs...). We supply a PHY device argument to make sure the
switch driver can act on the PHY device if needed (like putting/taking
the PHY out of deep low power mode).

Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

2014-09-28 17:14:08 -04:00

..

dsa_priv.h

net: dsa: allow switch drivers to implement suspend/resume hooks

2014-09-22 14:41:23 -04:00

dsa.c

net: dsa: allow switch drivers to implement suspend/resume hooks

2014-09-22 14:41:23 -04:00

Kconfig

net: dsa: add Broadcom tag RX/TX handler

2014-08-27 22:59:40 -07:00

Makefile

net: dsa: add Broadcom tag RX/TX handler

2014-08-27 22:59:40 -07:00

slave.c

net: dsa: allow enabling and disable switch ports

2014-09-28 17:14:08 -04:00

tag_brcm.c

dsa: Split ops up, and avoid assigning tag_protocol and receive separately

2014-09-15 17:24:20 -04:00

tag_dsa.c

dsa: Split ops up, and avoid assigning tag_protocol and receive separately

2014-09-15 17:24:20 -04:00

tag_edsa.c

dsa: Split ops up, and avoid assigning tag_protocol and receive separately

2014-09-15 17:24:20 -04:00

tag_trailer.c

dsa: Split ops up, and avoid assigning tag_protocol and receive separately

2014-09-15 17:24:20 -04:00