mirror of
https://github.com/FEX-Emu/linux.git
synced 2024-12-27 11:55:53 +00:00
c9e617a563
The pen down IRQ will toggle during each X,Y,Z measurement cycle. Even though the IRQ is disabled it will be latched and delivered when after enable_irq. Thus in the IRQ handler we must avoid starting a new measurement cycle when such an "unwanted" IRQ happens. Add a get_pendown_state platform function, which will probably determine this by reading the current GPIO level of the pen IRQ pin. Move the IRQ reenabling from the SPI RX function to the timer. After the last power down message the pen IRQ pin is still active for a while and get_pendown_state would report incorrectly a pen down state. When suspending we should check the ts->pending flag instead of ts->pendown, since the timer can be pending regardless of ts->pendown. Also if ts->pending is set we can be sure that the timer is running, so no need to rearm it. Similarly if ts->pending is not set we can be sure that the IRQ is enabled (and the timer is not). Signed-off-by: Imre Deak <imre.deak@nokia.com> Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Dmitry Torokhov <dtor@mail.ru> |
||
|---|---|---|
| .. | ||
| ads7846.c | ||
| corgi_ts.c | ||
| elo.c | ||
| gunze.c | ||
| h3600_ts_input.c | ||
| hp680_ts_input.c | ||
| Kconfig | ||
| Makefile | ||
| mk712.c | ||
| mtouch.c | ||