mirror of
https://github.com/FEX-Emu/linux.git
synced 2024-12-23 01:40:30 +00:00
970e248649
Usage of /etc/modprobe.conf file was deprecated by module-init-tools and is no longer parsed by new kmod tool. References to this file are replaced in Documentation, comments and Kconfig according to the context. There are also some references to the old /etc/modules.conf from 2.4 kernels that are being removed. Signed-off-by: Lucas De Marchi <lucas.demarchi@profusion.mobi> Acked-by: Takashi Iwai <tiwai@suse.de> Acked-by: Mauro Carvalho Chehab <mchehab@redhat.com> Signed-off-by: Randy Dunlap <rdunlap@xenotime.net> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
33 lines
1.0 KiB
Plaintext
33 lines
1.0 KiB
Plaintext
Kernel driver scx200_acb
|
|
|
|
Author: Christer Weinigel <wingel@nano-system.com>
|
|
|
|
The driver supersedes the older, never merged driver named i2c-nscacb.
|
|
|
|
Module Parameters
|
|
-----------------
|
|
|
|
* base: up to 4 ints
|
|
Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices
|
|
|
|
By default the driver uses two base addresses 0x820 and 0x840.
|
|
If you want only one base address, specify the second as 0 so as to
|
|
override this default.
|
|
|
|
Description
|
|
-----------
|
|
|
|
Enable the use of the ACCESS.bus controller on the Geode SCx200 and
|
|
SC1100 processors and the CS5535 and CS5536 Geode companion devices.
|
|
|
|
Device-specific notes
|
|
---------------------
|
|
|
|
The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820.
|
|
If the scx200_acb driver is built into the kernel, add the following
|
|
parameter to your boot command line:
|
|
scx200_acb.base=0x810,0x820
|
|
If the scx200_acb driver is built as a module, add the following line to
|
|
a configuration file in /etc/modprobe.d/ instead:
|
|
options scx200_acb base=0x810,0x820
|