..
8250
serial: 8250: move rx_running out of the bitfield
2015-08-14 17:19:50 -07:00
cpm_uart
tty: cpm_uart: replace CONFIG_8xx by CONFIG_CPM1
2015-03-26 23:00:36 +01:00
jsm
serial: jsm: some off by one bugs
2015-03-26 23:00:36 +01:00
21285.c
68328serial.c
tty: 68328serial.c: move assignment out of if () block
2015-05-10 19:04:16 +02:00
altera_jtaguart.c
drivers/tty/serial: altera: fix typos in #endif comments
2015-05-06 22:26:58 +02:00
altera_uart.c
drivers/tty/serial: altera: fix typos in #endif comments
2015-05-06 22:26:58 +02:00
amba-pl010.c
amba-pl011.c
uart: pl011: Add support to ZTE ZX296702 uart
2015-08-04 22:07:26 -07:00
apbuart.c
tty: constify of_device_id array
2015-03-26 22:49:10 +01:00
apbuart.h
ar933x_uart.c
serial: ar933x_uart: Fix off-by-one for checking valid alias id
2015-03-07 03:20:25 +01:00
arc_uart.c
atmel_serial.c
tty/serial: at91: fix I/O accesses on RHR and THR for AVR32
2015-08-04 22:07:22 -07:00
bcm63xx_uart.c
tty: serial/bcm63xx_uart: fix sparse warning
2015-03-07 03:13:07 +01:00
bfin_sport_uart.c
bfin_sport_uart.h
bfin_uart.c
serial: bfin: ctsrts: enfore Kconfig naming convention
2015-05-06 22:26:59 +02:00
clps711x.c
serial: clps711x: fail if mctrl_gpio_init fails
2015-03-07 03:15:03 +01:00
crisv10.c
tty: crisv10.c: move assignment out of if () block
2015-05-10 19:04:17 +02:00
crisv10.h
digicolor-usart.c
dz.c
dz.h
earlycon-arm-semihost.c
earlycon.c
serial: earlycon: Add support for big-endian MMIO accesses
2015-06-01 06:55:12 +09:00
efm32-uart.c
etraxfs-uart.c
serial: etraxfs-uart: use mctrl_gpio helpers for handling modem signals
2015-08-04 22:07:20 -07:00
fsl_lpuart.c
Merge 4.0-rc7 into tty-next
2015-04-07 11:07:20 +02:00
icom.c
tty: icom.c: move assignment out of if () block
2015-05-10 19:04:17 +02:00
icom.h
ifx6x60.c
serial: ifx6x60: Remove superfluous casts when calling request_irq()
2015-05-06 22:27:01 +02:00
ifx6x60.h
imx.c
Serial: imx: add dev_pm_ops to support suspend to ram/disk
2015-08-03 15:51:19 -07:00
ioc3_serial.c
tty: ioc3_serial.c: move assignment out of if () block
2015-05-10 19:04:17 +02:00
ioc4_serial.c
tty: ioc4_serial.c: move assignment out of if () block
2015-05-10 19:04:17 +02:00
ip22zilog.c
ip22zilog.h
Kconfig
uart: pl011: Add support to ZTE ZX296702 uart
2015-08-04 22:07:26 -07:00
kgdb_nmi.c
serial: kgdb_nmi: Use bool function return values of true/false not 1/0
2015-05-06 22:26:57 +02:00
kgdboc.c
lantiq.c
drivers/tty: make serial/lantic.c driver explicitly non-modular
2015-07-23 18:27:41 -07:00
lpc32xx_hs.c
m32r_sio_reg.h
m32r_sio.c
m32r_sio.h
Makefile
serial: stm32-usart: Add STM32 USART Driver
2015-06-10 17:34:26 -07:00
max310x.c
max3100.c
tty: max3100: use msecs_to_jiffies for time conversion
2015-03-07 03:13:08 +01:00
mcf.c
drivers/tty/serial/mcf.c: fix typo on SERIAL_MCF_CONSOLE
2015-05-06 22:26:59 +02:00
men_z135_uart.c
tty: serial: men_z135_uart.c: Don't initialize port->lock
2015-08-14 17:14:13 -07:00
meson_uart.c
ARM: meson: serial: convert iounmap to devm_iounmap
2015-05-06 22:27:02 +02:00
mpc52xx_uart.c
serial: mpc52xx: let tx_empty callback return either 0 or TIOCSER_TEMT
2015-08-04 22:07:20 -07:00
mpsc.c
tty: mpsc.c: move assignment out of if () block
2015-05-10 19:04:17 +02:00
msm_serial.c
msm_serial.h
tty: serial: msm_serial: Remove dead code
2015-03-26 22:31:09 +01:00
mux.c
mxs-auart.c
serial: mxs-auart: fix baud rate range
2015-08-14 17:08:48 -07:00
netx-serial.c
nwpserial.c
of_serial.c
serial: of_serial: check the return value of clk_prepare_enable()
2015-06-01 06:55:12 +09:00
omap-serial.c
serial: omap: Switch wake-up interrupt to generic wakeirq
2015-06-09 23:35:00 -07:00
pch_uart.c
pmac_zilog.c
tty: constify of_device_id array
2015-03-26 22:49:10 +01:00
pmac_zilog.h
pnx8xxx_uart.c
pxa.c
tty: constify of_device_id array
2015-03-26 22:49:10 +01:00
rp2.c
sa1100.c
samsung.c
serial: samsung: fix DMA for FIFO smaller than cache line size
2015-08-04 22:07:24 -07:00
samsung.h
serial: samsung: fix DMA mode enter condition for small FIFO sizes
2015-08-04 22:07:23 -07:00
sb1250-duart.c
sc16is7xx.c
sc16is7xx: constify devtype
2015-08-04 22:07:27 -07:00
sccnxp.c
serial_core.c
serial: core: Remove tty port activate() and shutdown() methods
2015-08-04 22:07:23 -07:00
serial_ks8695.c
tty/serial: kill off set_irq_flags usage
2015-06-09 12:26:32 -07:00
serial_mctrl_gpio.c
TTY/Serial driver patches for 4.2-rc1
2015-06-26 15:53:22 -07:00
serial_mctrl_gpio.h
serial_txx9.c
serial-tegra.c
serial: tegra: Fix memory leak on DMA setup failure
2015-05-24 12:53:44 -07:00
sh-sci.c
TTY/Serial driver patches for 4.2-rc1
2015-06-26 15:53:22 -07:00
sh-sci.h
serial: sh-sci: Replace hardcoded overrun bit values
2015-05-10 19:06:39 +02:00
sirfsoc_uart.c
serial: sirf: let uart's receive start in right place
2015-07-23 15:32:04 -07:00
sirfsoc_uart.h
serial: sirf: let uart's receive start in right place
2015-07-23 15:32:04 -07:00
sn_console.c
drivers/tty: make serial/sn_console.c driver explicitly non-modular
2015-07-23 18:27:41 -07:00
sprd_serial.c
serial: sprd: check for NULL after calling devm_clk_get
2015-06-12 17:39:50 -07:00
st-asc.c
tty: constify of_device_id array
2015-03-26 22:49:10 +01:00
stm32-usart.c
serial: stm32-usart: Fix SysRq support
2015-07-23 17:37:53 -07:00
suncore.c
drivers/tty: make serial/suncore.c driver explicitly non-modular
2015-07-23 18:27:41 -07:00
sunhv.c
drivers/tty: make serial/sunhv.c driver explicitly non-modular
2015-07-23 18:27:41 -07:00
sunsab.c
sunsab.h
sunsu.c
sunzilog.c
sunzilog.h
tilegx.c
timbuart.c
timbuart.h
uartlite.c
serial: xilinx: Use platform_get_irq to get irq description structure
2015-04-28 14:26:21 +02:00
ucc_uart.c
serial/uuc_uart: Support higher bitrates than 115200 Bit/s
2015-07-23 18:05:00 -07:00
vr41xx_siu.c
vt8500_serial.c
xilinx_uartps.c
serial: xuartps: add __init to earlycon write method
2015-05-10 19:10:08 +02:00
zs.c
zs.h
eafb9eea76