mirror of
https://github.com/FEX-Emu/linux.git
synced 2024-12-30 13:38:40 +00:00
3322c7bbf6
With the Blackfin on-chip SPI peripheral, there is some logic tied to the CPHA bit whether the Slave Select Line is controlled by hardware (CPHA=0) or controlled by software (CPHA=1). However, the Linux SPI bus driver assumes that the Slave Select being asserted during the entire SPI transfer. So explain these small details for people who need certain SPI modes with standard CS behavior. Signed-off-by: Michael Hennerich <michael.hennerich@analog.com> Signed-off-by: Mike Frysinger <vapier@gentoo.org>
15 lines
726 B
Plaintext
15 lines
726 B
Plaintext
SPI Chip Select behavior:
|
|
|
|
With the Blackfin on-chip SPI peripheral, there is some logic tied to the CPHA
|
|
bit whether the Slave Select Line is controlled by hardware (CPHA=0) or
|
|
controlled by software (CPHA=1). However, the Linux SPI bus driver assumes that
|
|
the Slave Select is always under software control and being asserted during
|
|
the entire SPI transfer. - And not just bits_per_word duration.
|
|
|
|
In most cases you can utilize SPI MODE_3 instead of MODE_0 to work-around this
|
|
behavior. If your SPI slave device in question requires SPI MODE_0 or MODE_2
|
|
timing, you can utilize the GPIO controlled SPI Slave Select option instead.
|
|
|
|
You can even use the same pin whose peripheral role is a SSEL,
|
|
but use it as a GPIO instead.
|