gecko-dev/netwerk/base/public/nsITransport.idl

/* ***** BEGIN LICENSE BLOCK *****
 * Version: MPL 1.1/GPL 2.0/LGPL 2.1
 *
 * The contents of this file are subject to the Mozilla Public License Version
 * 1.1 (the "License"); you may not use this file except in compliance with
 * the License. You may obtain a copy of the License at
 * http://www.mozilla.org/MPL/
 *
 * Software distributed under the License is distributed on an "AS IS" basis,
 * WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
 * for the specific language governing rights and limitations under the
 * License.
 *
 * The Original Code is Mozilla.
 *
 * The Initial Developer of the Original Code is
 * Netscape Communications Corporation.
 * Portions created by the Initial Developer are Copyright (C) 2002
 * the Initial Developer. All Rights Reserved.
 *
 * Contributor(s):
 *   Darin Fisher <darin@netscape.com>
 *
 * Alternatively, the contents of this file may be used under the terms of
 * either the GNU General Public License Version 2 or later (the "GPL"), or
 * the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
 * in which case the provisions of the GPL or the LGPL are applicable instead
 * of those above. If you wish to allow use of your version of this file only
 * under the terms of either the GPL or the LGPL, and not to allow others to
 * use your version of this file under the terms of the MPL, indicate your
 * decision by deleting the provisions above and replace them with the notice
 * and other provisions required by the GPL or the LGPL. If you do not delete
 * the provisions above, a recipient may use your version of this file under
 * the terms of any one of the MPL, the GPL or the LGPL.
 *
 * ***** END LICENSE BLOCK ***** */

#include "nsISupports.idl"

interface nsIInputStream;
interface nsIOutputStream;
interface nsITransportEventSink;
interface nsIEventTarget;

/**
 * nsITransport
 *
 * This interface provides a common way of accessing i/o streams connected
 * to some resource.  This interface does not in any way specify the resource.
 * It provides methods to open blocking or non-blocking, buffered or unbuffered
 * streams to the resource.  The name "transport" is meant to connote the 
 * inherent data transfer implied by this interface (i.e., data is being
 * transfered in some fashion via the streams exposed by this interface).
 *
 * A transport can have an event sink associated with it.  The event sink 
 * receives transport-specific events as the transfer is occuring.  For a
 * socket transport, these events can include status about the connection.
 * See nsISocketTransport for more info about socket transport specifics.
 */
[scriptable, uuid(d8786c64-eb49-4a0b-b42c-0936a745fbe8)]
interface nsITransport : nsISupports
{
    /**
     * Open flags.
     */
    const unsigned long OPEN_BLOCKING   = 1<<0;
    const unsigned long OPEN_UNBUFFERED = 1<<1;

    /**
     * Open an input stream on this transport.
     *
     * Flags have the following meaning:
     *
     * OPEN_BLOCKING
     *   If specified, then the resulting stream will have blocking stream
     *   semantics.  This means that if the stream has no data and is not
     *   closed, then reading from it will block the calling thread until
     *   at least one byte is available or until the stream is closed.
     *   If this flag is NOT specified, then the stream has non-blocking
     *   stream semantics.  This means that if the stream has no data and is
     *   not closed, then reading from it returns NS_BASE_STREAM_WOULD_BLOCK.
     *   In addition, in non-blocking mode, the stream is guaranteed to 
     *   support nsIAsyncInputStream.  This interface allows the consumer of
     *   the stream to be notified when the stream can again be read.
     *
     * OPEN_UNBUFFERED
     *   If specified, the resulting stream may not support ReadSegments.
     *   ReadSegments is only gauranteed to be implemented when this flag is
     *   NOT specified.
     *
     * @param aFlags
     *        optional transport specific flags.
     * @param aSegmentSize
     *        if OPEN_UNBUFFERED is not set, then this parameter specifies the
     *        size of each buffer segment (pass 0 to use default value).
     * @param aSegmentCount
     *        if OPEN_UNBUFFERED is not set, then this parameter specifies the
     *        maximum number of buffer segments (pass 0 to use default value).
     */
    nsIInputStream openInputStream(in unsigned long aFlags,
                                   in unsigned long aSegmentSize,
                                   in unsigned long aSegmentCount);

    /**
     * Open an output stream on this transport.
     *
     * Flags have the following meaning:
     *
     * OPEN_BLOCKING
     *   If specified, then the resulting stream will have blocking stream
     *   semantics.  This means that if the stream is full and is not closed,
     *   then writing to it will block the calling thread until ALL of the
     *   data can be written or until the stream is closed.  If this flag is
     *   NOT specified, then the stream has non-blocking stream semantics.
     *   This means that if the stream is full and is not closed, then writing
     *   to it returns NS_BASE_STREAM_WOULD_BLOCK.  In addition, in non-
     *   blocking mode, the stream is guaranteed to support
     *   nsIAsyncOutputStream.  This interface allows the consumer of the
     *   stream to be notified when the stream can again accept more data.
     *
     * OPEN_UNBUFFERED
     *   If specified, the resulting stream may not support WriteSegments and
     *   WriteFrom.  WriteSegments and WriteFrom are only gauranteed to be
     *   implemented when this flag is NOT specified.
     *
     * @param aFlags
     *        optional transport specific flags.
     * @param aSegmentSize
     *        if OPEN_UNBUFFERED is not set, then this parameter specifies the
     *        size of each buffer segment (pass 0 to use default value).
     * @param aSegmentCount
     *        if OPEN_UNBUFFERED is not set, then this parameter specifies the
     *        maximum number of buffer segments (pass 0 to use default value).
     */
    nsIOutputStream openOutputStream(in unsigned long aFlags,
                                     in unsigned long aSegmentSize,
                                     in unsigned long aSegmentCount);

    /**
     * Close the transport and any open streams.
     *
     * @param aReason
     *        the reason for closing the stream.
     */
    void close(in nsresult aReason);

    /**
     * Set the transport event sink.
     *
     * @param aSink
     *        receives transport layer notifications
     * @param aEventTarget
     *        indicates the event target to which the notifications should
     *        be delivered.  if NULL, then the notifications may occur on
     *        any thread.
     */
    void setEventSink(in nsITransportEventSink aSink,
                      in nsIEventTarget aEventTarget); 
    
    /**
     * Generic nsITransportEventSink status codes.  nsITransport
     * implementations may override these status codes with their own more
     * specific status codes (e.g., see nsISocketTransport).
     */
    const unsigned long STATUS_READING = 0x804b0008;
    const unsigned long STATUS_WRITING = 0x804b0009;
};

[scriptable, uuid(EDA4F520-67F7-484b-A691-8C3226A5B0A6)]
interface nsITransportEventSink : nsISupports
{
    /**
     * Transport status notification.
     *
     * @param aTransport
     *        the transport sending this status notification.
     * @param aStatus
     *        the transport status (resolvable to a string using
     *        nsIErrorService). See nsISocketTransport for socket specific
     *        status codes and more comments.
     * @param aProgress
     *        the amount of data either read or written depending on the value
     *        of the status code.  this value is relative to aProgressMax.
     * @param aProgressMax
     *        the maximum amount of data that will be read or written.  if
     *        unknown, 0xFFFFFFFF will be passed.
     */
    void onTransportStatus(in nsITransport aTransport,
                           in nsresult aStatus,
                           in unsigned long long aProgress,
                           in unsigned long long aProgressMax);
};