gecko-dev/rdf/base/idl/nsIRDFRemoteDataSource.idl

77 lines
2.7 KiB
Plaintext

/* -*- Mode: C++; tab-width: 4; indent-tabs-mode: nil; c-basic-offset: 4 -*- */
/* ***** BEGIN LICENSE BLOCK *****
* Version: NPL 1.1/GPL 2.0/LGPL 2.1
*
* The contents of this file are subject to the Netscape Public License
* Version 1.1 (the "License"); you may not use this file except in
* compliance with the License. You may obtain a copy of the License at
* http://www.mozilla.org/NPL/
*
* Software distributed under the License is distributed on an "AS IS" basis,
* WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
* for the specific language governing rights and limitations under the
* License.
*
* The Original Code is mozilla.org code.
*
* The Initial Developer of the Original Code is
* Netscape Communications Corporation.
* Portions created by the Initial Developer are Copyright (C) 1998
* the Initial Developer. All Rights Reserved.
*
* Contributor(s):
*
* Alternatively, the contents of this file may be used under the terms of
* either the GNU General Public License Version 2 or later (the "GPL"), or
* the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
* in which case the provisions of the GPL or the LGPL are applicable instead
* of those above. If you wish to allow use of your version of this file only
* under the terms of either the GPL or the LGPL, and not to allow others to
* use your version of this file under the terms of the NPL, indicate your
* decision by deleting the provisions above and replace them with the notice
* and other provisions required by the GPL or the LGPL. If you do not delete
* the provisions above, a recipient may use your version of this file under
* the terms of any one of the NPL, the GPL or the LGPL.
*
* ***** END LICENSE BLOCK ***** */
#include "nsISupports.idl"
/**
* A datasource that may load asynchronously
*/
[scriptable, uuid(1D297320-27F7-11d3-BE01-000064657374)]
interface nsIRDFRemoteDataSource : nsISupports
{
/**
* This value is <code>true</code> when the datasource has
* fully loaded itself.
*/
readonly attribute boolean loaded;
/**
* Specify the URI for the data source: this is the prefix
* that will be used to register the data source in the
* data source registry.
* @param aURI the URI to load
*/
void Init(in string aURI);
/**
* Refresh the remote datasource, re-loading its contents
* from the URI.
*
* @param aBlocking If <code>true</code>, the call will block
* until the datasource has completely reloaded.
*/
void Refresh(in boolean aBlocking);
/**
* Request that a data source write it's contents out to
* permanent storage, if applicable.
*/
void Flush();
void FlushTo(in string aURI);
};