a) frame setup instructions define the prologue
b) we shouldn't change our location mid-stream
Add a test to make sure that the stack adjustment stays within
the prologue.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@165250 91177308-0d34-0410-b5e6-96231b3b80d8
multiple stores with a single load. We create the wide loads and stores (and their chains)
before we remove the scalar loads and stores and fix the DAG chain. We attempted to merge
loads with a different chain. When that happened, the assumption that it is safe to RAUW
broke and a cycle was introduced.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@165148 91177308-0d34-0410-b5e6-96231b3b80d8
is not profitable in many cases because modern processors perform multiple stores
in parallel and merging stores prior to merging requires extra work. We handle two main cases:
1. Store of multiple consecutive constants:
q->a = 3;
q->4 = 5;
In this case we store a single legal wide integer.
2. Store of multiple consecutive loads:
int a = p->a;
int b = p->b;
q->a = a;
q->b = b;
In this case we load/store either ilegal vector registers or legal wide integer registers.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@165125 91177308-0d34-0410-b5e6-96231b3b80d8
Enable the pass by default for targets that request it, and change the
-enable-early-ifcvt to the opposite -disable-early-ifcvt.
There are still some x86 regressions when enabling early if-conversion
because of the missing machine models. Disable the pass for x86 until
machine models are added.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@165075 91177308-0d34-0410-b5e6-96231b3b80d8
Reserved register live ranges look like a set of dead defs - any uses of
reserved registers are ignored.
Instead of skipping the updating of reserved register operands entirely,
just ignore the use operands and treat the def operands normally.
No test case, handleMove() is not commonly used yet.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@165060 91177308-0d34-0410-b5e6-96231b3b80d8
JoinVals::pruneValues() calls LIS->pruneValue() to avoid conflicts when
overlapping two different values. This produces a set of live range end
points that are used to reconstruct the live range (with SSA update)
after joining the two registers.
When a value is pruned twice, the set of end points was insufficient:
v1 = DEF
v1 = REPLACE1
v1 = REPLACE2
KILL v1
The end point at KILL would only reconstruct the live range from
REPLACE2 to KILL, leaving the range REPLACE1-REPLACE2 dead.
Add REPLACE2 as an end point in this case so the full live range is
reconstructed.
This fixes PR13999.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@165056 91177308-0d34-0410-b5e6-96231b3b80d8
the add/sub case since in the case of multiplication you also have to check that
the operation in the larger type did not overflow.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@165017 91177308-0d34-0410-b5e6-96231b3b80d8
because moden processos can store multiple values in parallel, and preparing the consecutive store requires
some work. We only handle these cases:
1. Consecutive stores where the values and consecutive loads. For example:
int a = p->a;
int b = p->b;
q->a = a;
q->b = b;
2. Consecutive stores where the values are constants. Foe example:
q->a = 4;
q->b = 5;
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164910 91177308-0d34-0410-b5e6-96231b3b80d8
buildbots. Original commit message:
A DAGCombine optimization for merging consecutive stores. This optimization is not profitable in many cases
because moden processos can store multiple values in parallel, and preparing the consecutive store requires
some work. We only handle these cases:
1. Consecutive stores where the values and consecutive loads. For example:
int a = p->a;
int b = p->b;
q->a = a;
q->b = b;
2. Consecutive stores where the values are constants. Foe example:
q->a = 4;
q->b = 5;
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164890 91177308-0d34-0410-b5e6-96231b3b80d8
because moden processos can store multiple values in parallel, and preparing the consecutive store requires
some work. We only handle these cases:
1. Consecutive stores where the values and consecutive loads. For example:
int a = p->a;
int b = p->b;
q->a = a;
q->b = b;
2. Consecutive stores where the values are constants. Foe example:
q->a = 4;
q->b = 5;
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164885 91177308-0d34-0410-b5e6-96231b3b80d8
The new coalescer can turn a full virtual register definition into a
partial redef by merging another value into an unused vector lane.
Make sure to clear the <read-undef> flag on such defs.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164807 91177308-0d34-0410-b5e6-96231b3b80d8
The fix is obvious and the only test case I have is horrible, so I am
not including it. The problem shows up when self-hosting clang on i386
with -new-coalescer enabled.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164793 91177308-0d34-0410-b5e6-96231b3b80d8
The hasFnAttr method has been replaced by querying the Attributes explicitly. No
intended functionality change.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164725 91177308-0d34-0410-b5e6-96231b3b80d8
scalar-to-vector conversion that we cannot handle. For instance, when an invalid
constraint is used in an inline asm statement.
<rdar://problem/12284092>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164662 91177308-0d34-0410-b5e6-96231b3b80d8
scalar-to-vector conversion that we cannot handle. For instance, when an invalid
constraint is used in an inline asm statement.
<rdar://problem/12284092>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164657 91177308-0d34-0410-b5e6-96231b3b80d8
Provide interface in TargetLowering to set or get the minimum number of basic
blocks whereby jump tables are generated for switch statements rather than an
if sequence.
getMinimumJumpTableEntries() defaults to 4.
setMinimumJumpTableEntries() allows target configuration.
This patch changes the default for the Hexagon architecture to 5
as it improves performance on some benchmarks.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164628 91177308-0d34-0410-b5e6-96231b3b80d8
Even out-of-line jump tables can be in the code section, so mark them
as data-regions for those targets which support the directives.
rdar://12362871&12362974
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164571 91177308-0d34-0410-b5e6-96231b3b80d8
care about it being an argument variable so that we can decide
that captured block and lambda vars that don't happen to
be arguments could be an argument pointer.
Add the object pointer for one case onto the subprogram die.
rdar://12001329
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164419 91177308-0d34-0410-b5e6-96231b3b80d8
because LiveStackAnalysis was not preserved by VirtRegWriter. This caused
big stack usage regression in some cases.
rdar://12340383
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164408 91177308-0d34-0410-b5e6-96231b3b80d8
A PHI can't create interference on its own. If two live ranges interfere
at a PHI, they must also interfere when leaving one of the PHI
predecessors.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164330 91177308-0d34-0410-b5e6-96231b3b80d8
The old-fashioned many-to-one value mapping doesn't always work when
merging vector lanes. A value can map to multiple different values, and
it can even be necessary to insert new PHIs.
When a value number is defined by a copy from a value number that
required SSa update, include the live range of the copied value number
in the SSA update as well. It is not necessarily a copy of the original
value number any longer.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164329 91177308-0d34-0410-b5e6-96231b3b80d8
