mirror of
https://github.com/hacks-guide/Guide_3DS.git
synced 2024-11-28 03:40:46 +00:00
39 lines
1.7 KiB
Plaintext
39 lines
1.7 KiB
Plaintext
---
|
|
title: "Installing boot9strap (SafeB9SInstaller)"
|
|
---
|
|
|
|
{% include toc title="Table of Contents" %}
|
|
|
|
### Instructions
|
|
|
|
#### Section I - Launching SafeB9SInstaller
|
|
|
|
1. Launch udsploit from the list of homebrew
|
|
1. Once it has completed, press (Start) to exit udsploit
|
|
+ This may take several tries
|
|
+ 画面がフリーズした場合、電源ボタン長押しで強制的に電源を切り、もう一度やり直してください
|
|
1. Launch safehax from the list of homebrew
|
|
+ If you get a "PM INIT FAILED" error, make sure you ran udsploit with Wireless Communication turned on
|
|
+ If you *still* get a "PM INIT FAILED" error, try using the [r19 release of safehax](https://github.com/TiniVi/safehax/releases/tag/r19)
|
|
+ 画面がフリーズした場合、電源ボタン長押しで強制的に電源を切り、もう一度やり直してください
|
|
1. If the exploit was successful, you will have booted into SafeB9SInstaller
|
|
|
|
#### Section II - Installing boot9strap
|
|
|
|
1. Wait for all safety checks to complete
|
|
1. When prompted, input the key combo given to install boot9strap
|
|
1. Once it has completed, press (A) to reboot your device
|
|
|
|
#### Section III - Configuring Luma3DS
|
|
|
|
1. Your device should have rebooted into the Luma3DS configuration menu
|
|
+ If you get a black screen, [follow this troubleshooting guide](troubleshooting#black-screen-on-sysnand-boot-after-installing-boot9strap)
|
|
1. Use the (A) button and the D-Pad to turn on the following:
|
|
+ **「Show NAND or user string in System Settings」**
|
|
1. (Start) を押してセーブして再起動します
|
|
+ If you get an error, just continue the next page
|
|
|
|
___
|
|
|
|
### Continue to [Finalizing Setup](finalizing-setup)
|
|
{: .notice--primary} |