Guide_3DS/_pages/tr_TR/installing-boot9strap-(homebrew-launcher).txt
2018-11-18 19:17:21 -05:00

43 lines
2.0 KiB
Plaintext
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

---
title: "Installing boot9strap (Homebrew Launcher)"
---
{% include toc title = "İçindekiler"%}
### Okumanız Gerekli
If you have already hacked your device before and have a EmuNAND based CFW setup, this guide deals exclusively with SysNAND and you should follow all instructions from within or applying to SysNAND. EmuNAND ve RedNAND terimlerinin, birbirinden farklı uygulamalara işaret ettiğini unutmayın.[aynı konsept](http://3dbrew.org/wiki/NAND_Redirection).
### Instructions
#### Section I - Launching SafeB9SInstaller
1. Launch udsploit from the list of homebrew
1. Once it has completed, press (Start) to exit udsploit
+ This may take several tries
+ Eğer donarsa, konsolun kapatma tuşuna konsol kapanana kadar basın, sonra tekrar deneyin
1. Launch safehax from the list of homebrew
+ If you get a "PM INIT FAILED" error, make sure you ran udsploit with Wireless Communication turned on
+ If you *still* get a "PM INIT FAILED" error, try using the [r19 release of safehax](https://github.com/TiniVi/safehax/releases/tag/r19)
+ Eğer donarsa, konsolun kapatma tuşuna konsol kapanana kadar basın, sonra tekrar deneyin
1. If the exploit was successful, you will have booted into SafeB9SInstaller
#### Section II - Installing boot9strap
1. Wait for all safety checks to complete
1. When prompted, input the key combo given to install boot9strap
1. Once it has completed, press (A) to reboot your device
#### Section III - Configuring Luma3DS
1. Your device should have rebooted into the Luma3DS configuration menu
+ If you get a black screen, [follow this troubleshooting guide](troubleshooting#black-screen-on-sysnand-boot-after-installing-boot9strap)
1. Use the (A) button and the D-Pad to turn on the following:
+ **"Show NAND or user string in System Settings"**
1. Kaydedip yeniden başlatmak için (Start) basın
+ If you get an error, just continue the next page
___
### Continue to [Finalizing Setup](finalizing-setup)
{: .notice--primary}