We update the QTAILQ in the loop, thus we must use the SAFE version
to make sure we don't touch the queue struct after freeing it.
https://bugzilla.novell.com/show_bug.cgi?id=766310
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
The multifunction ich9 ehci controller with uhci companions uses a
different interrupt pin for each function. The three uhci devices
get pins A, B and C, whereas ehci uses pin D. This way the guest
can assign different IRQ lines to each controller.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Cancel transactions before saving vmstate is pretty pointless and just
causes disruptions. We need to cancel them before *loading* vmstate,
but in that case uhci_reset() handles it already and no special action
is needed.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Add a property for the uhci bandwidth. Can be used to make uhci
emulation run faster than real hardware.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Schedule bottom half on completion of async packets instead of calling
uhci_process_frame directly. This way we run uhci_process_frame only
once in case multiple packets finish in a row. Also check whenever
there is bandwidth left before scheduling uhci_process_frame.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
uhci_process_frame() can be invoked multiple times per frame, so
accounting usb bandwith in a local variable doesn't fly, use a variable
in UHCIState instead. Also check the limit more frequently.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
uhci_reset() clears irq mask and irq status registers, but doesn't
update the irq line. Which may result in suspious IRQs after uhci
reset. Fix it.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
When we queue up usb packets we may happen to find a already queued
packet, which also might be finished at that point already. We don't
want continue processing the packet at this point though, so lets
just signal back we've found a in-flight packet when in queuing mode.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Not only QHs can form rings, but TDs too. With the new
queuing/pipelining support we are following TD chains and
can actually walk in circles. An assert() prevents us from
entering an endless loop then.
Fix is easy: Just stop queuing when we figure the TD we are
about to queue up is in flight already.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Step #2 (separate for better bisectability): renumber so the silly '-1'
goes away. Pick a range which doesn't overlap the old values.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Remove the uhci and ohci init wrappers, which all wrapped a
pci_create_simple() one-liner. Switch callsites to call
pci_create_simple directly. Remove the header files where
the wrappers where declared.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Reorganize usb source files. Create a new hw/usb/ directory and move
all usb source code to that place. Also make filenames a bit more
descriptive. Host adapters are prefixed with "hch-" now, usb device
emulations are prefixed with "dev-". Fixup paths Makefile and include
paths to make it compile. No code changes.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
