xemu/hw/ppc/Makefile.objs
Cédric Le Goater 35dde57662 ppc/pnv: Add a PNOR model
On a POWERPC PowerNV system, the host firmware is stored in a PNOR
flash chip which contents is mapped on the LPC bus. This model adds a
simple dummy device to map the contents of a block device in the host
address space.

Signed-off-by: Cédric Le Goater <clg@kaod.org>
Message-Id: <20191021131215.3693-2-clg@kaod.org>
Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
2019-12-17 10:39:47 +11:00

37 lines
1.4 KiB
Makefile

# shared objects
obj-y += ppc.o ppc_booke.o fdt.o fw_cfg.o
# IBM pSeries (sPAPR)
obj-$(CONFIG_PSERIES) += spapr.o spapr_caps.o spapr_vio.o spapr_events.o
obj-$(CONFIG_PSERIES) += spapr_hcall.o spapr_iommu.o spapr_rtas.o
obj-$(CONFIG_PSERIES) += spapr_pci.o spapr_rtc.o spapr_drc.o
obj-$(CONFIG_PSERIES) += spapr_cpu_core.o spapr_ovec.o spapr_irq.o
obj-$(CONFIG_PSERIES) += spapr_tpm_proxy.o
obj-$(CONFIG_SPAPR_RNG) += spapr_rng.o
# IBM PowerNV
obj-$(CONFIG_POWERNV) += pnv.o pnv_xscom.o pnv_core.o pnv_lpc.o pnv_psi.o pnv_occ.o pnv_bmc.o
obj-$(CONFIG_POWERNV) += pnv_homer.o pnv_pnor.o
ifeq ($(CONFIG_PCI)$(CONFIG_PSERIES)$(CONFIG_LINUX), yyy)
obj-y += spapr_pci_vfio.o spapr_pci_nvlink2.o
endif
obj-$(CONFIG_PSERIES) += spapr_rtas_ddw.o
# PowerPC 4xx boards
obj-$(CONFIG_PPC405) += ppc405_boards.o ppc405_uc.o
obj-$(CONFIG_PPC440) += ppc440_bamboo.o ppc440_pcix.o ppc440_uc.o
obj-$(CONFIG_PPC4XX) += ppc4xx_pci.o ppc4xx_devs.o
obj-$(CONFIG_SAM460EX) += sam460ex.o
# PReP
obj-$(CONFIG_PREP) += prep.o
obj-$(CONFIG_PREP) += prep_systemio.o
obj-${CONFIG_RS6000_MC} += rs6000_mc.o
# OldWorld PowerMac
obj-$(CONFIG_MAC_OLDWORLD) += mac_oldworld.o
# NewWorld PowerMac
obj-$(CONFIG_MAC_NEWWORLD) += mac_newworld.o
# e500
obj-$(CONFIG_E500) += e500.o mpc8544ds.o e500plat.o
obj-$(CONFIG_E500) += mpc8544_guts.o ppce500_spin.o
# PowerPC 440 Xilinx ML507 reference board.
obj-$(CONFIG_VIRTEX) += virtex_ml507.o