discard_port_data() used virtqueue_get_buf() directly instead of using
get_inbuf(). Fix this, so that we get accounting for all received
bytes. This also simplifies the code a lot.
Signed-off-by: Amit Shah <amit.shah@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Instead of pulling in a buffer from the vq each time it's called,
get_inbuf() now checks if the current active buffer, in port->inbuf is
valid. If it is, just returns a pointer to it. This ends up
simplifying a lot of code calling get_inbuf() since the check for
port->inbuf being valid was done by all the callers.
Signed-off-by: Amit Shah <amit.shah@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
get_inbuf() returns void *. There's no reason to return void pointers
instead of the correct struct port_buffer *.
Signed-off-by: Amit Shah <amit.shah@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Get ready to support suspend/resume by using the freezable calls so that
blocking read/write syscalls are handled properly across suspend/resume.
Signed-off-by: Amit Shah <amit.shah@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We don't allow port name changes dynamically for a port. So any
requests by the host to change the name are ignored.
Before this patch, if the hypervisor sent a port name while we had one
set already, we would leak memory equivalent to the size of the old
name.
This scenario wasn't expected so far, but with the suspend-resume
support, we'll send the VIRTIO_CONSOLE_PORT_READY message after restore,
which can get us into this situation.
Signed-off-by: Amit Shah <amit.shah@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Convert spaces to tabs and fix indentation for an if statement split
into multiple lines.
Signed-off-by: Amit Shah <amit.shah@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Based on the layout description in the comments, take account of
the *_event_idx in functions vring_init and vring_size.
Signed-off-by: Wang Sheng-Hui <shhuiw@gmail.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This patch modifies virtio-net to use virtio_config_val() instead
of a 'if(virtio_has_feature()) vdev->config->get()' construct to retrieve
optional values from the config space.
Cc: Amit Shah <amit.shah@redhat.com>
Cc: "Michael S. Tsirkin" <mst@redhat.com>
Cc: Rusty Russell <rusty@rustcorp.com.au>
Cc: virtualization@lists.linux-foundation.org
Signed-off-by: Sasha Levin <levinsasha928@gmail.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This patch adds virtio_config_val_len() which allows retrieving variable
length data from the virtio config space only if a specific feature is on.
Cc: Amit Shah <amit.shah@redhat.com>
Cc: "Michael S. Tsirkin" <mst@redhat.com>
Cc: Rusty Russell <rusty@rustcorp.com.au>
Cc: virtualization@lists.linux-foundation.org
Signed-off-by: Sasha Levin <levinsasha928@gmail.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This patch modifies virtio-console to use virtio_config_val() instead
of a 'if(virtio_has_feature()) vdev->config->get()' construct to retrieve
optional values from the config space.
Cc: Amit Shah <amit.shah@redhat.com>
Cc: "Michael S. Tsirkin" <mst@redhat.com>
Cc: Rusty Russell <rusty@rustcorp.com.au>
Cc: virtualization@lists.linux-foundation.org
Signed-off-by: Sasha Levin <levinsasha928@gmail.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
* 'for-linus/i2c-3.2' of git://git.fluff.org/bjdooks/linux: (47 commits)
i2c-s3c2410: Add device tree support
i2c-s3c2410: Keep a copy of platform data and use it
i2c-nomadik: cosmetic coding style corrections
i2c-au1550: dev_pm_ops conversion
i2c-au1550: increase timeout waiting for master done
i2c-au1550: remove unused ack_timeout
i2c-au1550: remove usage of volatile keyword
i2c-tegra: __iomem annotation fix
i2c-eg20t: Add initialize processing in case i2c-error occurs
i2c-eg20t: Fix flag setting issue
i2c-eg20t: add stop sequence in case wait-event timeout occurs
i2c-eg20t: Separate error processing
i2c-eg20t: Fix 10bit access issue
i2c-eg20t: Modify returned value s32 to long
i2c-eg20t: Fix bus-idle waiting issue
i2c-designware: Fix PCI core warning on suspend/resume
i2c-designware: Add runtime power management support
i2c-designware: Add support for Designware core behind PCI devices.
i2c-designware: Push all register reads/writes into the core code.
i2c-designware: Support multiple cores using same ISR
...
* 'for-linus' of git://opensource.wolfsonmicro.com/regulator: (22 commits)
regulator: Constify constraints name
regulator: Fix possible nullpointer dereference in regulator_enable()
regulator: gpio-regulator add dependency on GENERIC_GPIO
regulator: Add module.h include to gpio-regulator
regulator: Add driver for gpio-controlled regulators
regulator: remove duplicate REG_CTRL2 defines in tps65023
regulator: Clarify documentation for regulator-regulator supplies
regulator: Fix some bitrot in the machine driver documentation
regulator: tps65023: Added support for the similiar TPS65020 chip
regulator: tps65023: Setting correct core regulator for tps65021
regulator: tps65023: Set missing bit for update core-voltage
regulator: tps65023: Fixes i2c configuration issues
regulator: Add debugfs file showing the supply map table
regulator: tps6586x: add SMx slew rate setting
regulator: tps65023: Fixes i2c configuration issues
regulator: tps6507x: Remove num_voltages array
regulator: max8952: removed unused mutex.
regulator: fix regulator/consumer.h kernel-doc warning
regulator: Ensure enough enable time for max8649
regulator: 88pm8607: Fix off-by-one value range checking in the case of no id is matched
...
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/ieee1394/linux1394:
firewire: ohci: fix isochronous DMA synchronization
firewire: ohci: work around selfID junk due to wrong gap count
firewire: net: Use posted writes
firewire: use clamp and min3 macros
firewire: ohci: optimize TSB41BA3D detection
firewire: ohci: TSB41BA3D support tweaks
firewire: ohci: Add support for TSB41BA3D phy
firewire: ohci: Move code from the bus reset tasklet into a workqueue
firewire: sbp2: fold two functions into one
firewire: sbp2: move some code to more sensible places
firewire: sbp2: remove obsolete reference counting
* 'pstore' of git://git.kernel.org/pub/scm/linux/kernel/git/aegl/linux:
pstore: make pstore write function return normal success/fail value
pstore: change mutex locking to spin_locks
pstore: defer inserting OOPS entries into pstore
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband: (62 commits)
mlx4_core: Deprecate log_num_vlan module param
IB/mlx4: Don't set VLAN in IBoE WQEs' control segment
IB/mlx4: Enable 4K mtu for IBoE
RDMA/cxgb4: Mark QP in error before disabling the queue in firmware
RDMA/cxgb4: Serialize calls to CQ's comp_handler
RDMA/cxgb3: Serialize calls to CQ's comp_handler
IB/qib: Fix issue with link states and QSFP cables
IB/mlx4: Configure extended active speeds
mlx4_core: Add extended port capabilities support
IB/qib: Hold links until tuning data is available
IB/qib: Clean up checkpatch issue
IB/qib: Remove s_lock around header validation
IB/qib: Precompute timeout jiffies to optimize latency
IB/qib: Use RCU for qpn lookup
IB/qib: Eliminate divide/mod in converting idx to egr buf pointer
IB/qib: Decode path MTU optimization
IB/qib: Optimize RC/UC code by IB operation
IPoIB: Use the right function to do DMA unmap pages
RDMA/cxgb4: Use correct QID in insert_recv_cqe()
RDMA/cxgb4: Make sure flush CQ entries are collected on connection close
...
* git://github.com/herbertx/crypto: (48 commits)
crypto: user - Depend on NET instead of selecting it
crypto: user - Add dependency on NET
crypto: talitos - handle descriptor not found in error path
crypto: user - Initialise match in crypto_alg_match
crypto: testmgr - add twofish tests
crypto: testmgr - add blowfish test-vectors
crypto: Make hifn_795x build depend on !ARCH_DMA_ADDR_T_64BIT
crypto: twofish-x86_64-3way - fix ctr blocksize to 1
crypto: blowfish-x86_64 - fix ctr blocksize to 1
crypto: whirlpool - count rounds from 0
crypto: Add userspace report for compress type algorithms
crypto: Add userspace report for cipher type algorithms
crypto: Add userspace report for rng type algorithms
crypto: Add userspace report for pcompress type algorithms
crypto: Add userspace report for nivaead type algorithms
crypto: Add userspace report for aead type algorithms
crypto: Add userspace report for givcipher type algorithms
crypto: Add userspace report for ablkcipher type algorithms
crypto: Add userspace report for blkcipher type algorithms
crypto: Add userspace report for ahash type algorithms
...
In sysfs_rename we need to remove the optimization of not calling
sysfs_unlink_sibling and sysfs_link_sibling if the renamed parent
directory is not changing. This optimization is no longer valid now
that sysfs dirents are stored in an rbtree sorted by name.
Move the assignment of s_ns before the call of sysfs_link_sibling. With
no sysfs_dirent fields changing after the call of sysfs_link_sibling
this allows sysfs_link_sibling to take any of the directory entries into
account when it builds the rbtrees, and s_ns looks like a prime canidate
to be used in the rbtree in the future.
Signed-off-by: Eric W. Biederman <ebiederm@xmission.com>
Cc: Jiri Slaby <jirislaby@gmail.com>
Cc: Greg KH <gregkh@suse.de>
Cc: David Miller <davem@davemloft.net>
Cc: Mikulas Patocka <mpatocka@redhat.com>
Cc: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This is the fifth version of the patchset (with one tiny whitespace fix)
to the Linux kernel to support the Qualcomm Hexagon architecture.
Between now and the next pull requests, Richard Kuo should have his key
signed, etc., and should be back on kernel.org. In the meantime, this
got merged as a emailed patch-series.
* Hexagon: (36 commits)
Add extra arch overrides to asm-generic/checksum.h
Hexagon: Add self to MAINTAINERS
Hexagon: Add basic stacktrace functionality for Hexagon architecture.
Hexagon: Add configuration and makefiles for the Hexagon architecture.
Hexagon: Comet platform support
Hexagon: kgdb support files
Hexagon: Add page-fault support.
Hexagon: Add page table header files & etc.
Hexagon: Add ioremap support
Hexagon: Provide DMA implementation
Hexagon: Implement basic TLB management routines for Hexagon.
Hexagon: Implement basic cache-flush support
Hexagon: Provide basic implementation and/or stubs for I/O routines.
Hexagon: Add user access functions
Hexagon: Add locking types and functions
Hexagon: Add SMP support
Hexagon: Provide basic debugging and system trap support.
Hexagon: Add ptrace support
Hexagon: Add time and timer functions
Hexagon: Add interrupts
...
There are plausible reasons for architectures to provide their own
versions of csum_partial_copy_nocheck and csum_tcpudp_magic.
By protecting these, the architecture can still re-use the
asm-generic checksum.h, instead of copying it.
Signed-off-by: Linas Vepstas <linas@codeaurora.org>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Richard Kuo <rkuo@codeaurora.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Mostly all stubs, as the TLB is managed by the hypervisor.
Signed-off-by: Richard Kuo <rkuo@codeaurora.org>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Modules should be compiled as ordinary .o's; shared objects are not
supported.
Signed-off-by: Linas Vepstas <linas@codeaurora.org>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Richard Kuo <rkuo@codeaurora.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
