If the arch is P8, we will select XFLOAD to load the floating point, and then, expand it to vsx and non-vsx X-form instruction post RA. This patch is trying to convert the X-form to D-form if it meets the requirement that one operand of the x-form inst is the special Zero register, and another operand fed by add inst. i.e.
y = add imm, reg
LFDX. 0, y
-->
LFD imm(reg)
Reviewers: Nemanjai
Differential Revision: https://reviews.llvm.org/D49007
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@340149 91177308-0d34-0410-b5e6-96231b3b80d8
The match pattern in the definition of LXSDX is xoaddr, so the Pseudo
instruction XFLOADf64 never gets selected. XFLOADf64 expands to LXSDX/LFDX post
RA based on the register pressure. To avoid ambiguity, we need to remove the
select pattern for LXSDX, same as what was done for LXSD. STXSDX also have
the same issue.
Patch by Qing Shan Zhang (steven.zhang).
Differential Revision: https://reviews.llvm.org/D47178
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@333150 91177308-0d34-0410-b5e6-96231b3b80d8
This patch corresponds to review:
The newly added VSX D-Form (register + offset) memory ops target the upper half
of the VSX register set. The existing ones target the lower half. In order to
unify these and have the ability to target all the VSX registers using D-Form
operations, this patch defines Pseudo-ops for the loads/stores which are
expanded post-RA. The expansion then choses the correct opcode based on the
register that was allocated for the operation.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@283212 91177308-0d34-0410-b5e6-96231b3b80d8
Currently we have a number of tests that fail with -verify-machineinstrs.
To detect this cases earlier we add the option to the testcases with the
exception of tests that will currently fail with this option. PR 27456 keeps
track of this failures.
No code review, as discussed with Hal Finkel.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@277624 91177308-0d34-0410-b5e6-96231b3b80d8
When VSX is available, these instructions should be used in preference to the
older variants that only have access to the scalar floating-point registers.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@204559 91177308-0d34-0410-b5e6-96231b3b80d8
The P7 and A2 have additional floating-point conversion instructions which
allow a direct two-instruction sequence (plus load/store) to convert from all
combinations (signed/unsigned i32/i64) <--> (float/double) (on previous cores,
only some combinations were directly available).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178480 91177308-0d34-0410-b5e6-96231b3b80d8
