On Hexagon "x = y" is a syntax used in most instructions, and is not
treated as a directive.
Differential Revision: https://reviews.llvm.org/D44256
llvm-svn: 328635
This is part of fixing the instruction predicates for MIPS.
Reviewers: atanasyan, abeserminji
Differential Revision: https://reviews.llvm.org/D44212
llvm-svn: 327409
These instructions are defined as taking a GPR register and a
coprocessor register for ISAs up to MIPS32. MIPS32 extended the
definition to allow a selector--a value from 0 to 32--to access
another register.
These instructions are now internally defined as being MIPS-I
instructions, but are rejected for pre-MIPS32 ISA's if they have
an explicit selector which is non-zero. This deviates slightly from
GAS's behaviour which rejects assembly instructions with an
explicit selector for pre-MIPS32 ISAs.
E.g:
mfc0 $4, $5, 0
is rejected by GAS for MIPS-I to MIPS-V but will be accepted
with this patch for MIPS-I to MIPS-V.
Reviewers: atanasyan
Differential Revision: https://reviews.llvm.org/D41662
llvm-svn: 326890
An upcoming patch D41434, changes the ordering of the matcher table
for assembly. This patch corrects the definition of the normal MIPS
cvt.d.w not to be available in microMIPS.
llvm-svn: 325589
Instructions affected:
mthc1, mfhc1, add.d, sub.d, mul.d, div.d,
mov.d, neg.d, cvt.w.d, cvt.d.s, cvt.d.w, cvt.s.d
These instructions are now defined for
microMIPS32r3 + microMIPS32r6 in MicroMipsInstrFPU.td
since they shared their encoding with those already defined
in microMIPS32r6InstrInfo.td and have been therefore
removed from the latter file.
Some instructions present in MicroMipsInstrFPU.td which
did not have both AFGR64 and FGR64 variants defined have
been altered to do so.
Differential revision: https://reviews.llvm.org/D42738
llvm-svn: 324584
- Alter abs for micromips to have both AFGR64 and FGR64
variants, same as sqrt
- Remove sqrt and abs from MicroMips32r6InstrInfo.td,
use micromips FGR64 variants
- Restrict non-micromips abs/sqrt with NotInMicroMips
predicate
Differential revision: https://reviews.llvm.org/D41439
llvm-svn: 323184
During the review of D40362 I spotted that this test wasn't actually
testing the eva instructions due to '-mattr==eva', rather than '-mattr=+eva',
which resulted in test having no effect.
llvm-svn: 321273
This patch resubmits the SVE ZIP1/ZIP2 patch series consisting of
of r320992, r320986, r320973, and r320970 by reverting
https://reviews.llvm.org/rL321024.
The issue that caused r321024 has been addressed in https://reviews.llvm.org/rL321158,
so this patch-series should be safe to resubmit.
llvm-svn: 321163
This reverts changes r320992, r320986, r320973, and r320970.
r320970 by itself breaks the test case, and the rest depend on it.
Test case will land soon.
llvm-svn: 321024
Summary:
When emitting a diagnostic for an invalid operand, a specific diagnostic
should only be reported when the instruction being matched is actually
enabled by the feature flags.
Patch [3/4] in a series to add parsing of predicates and properly parse SVE
ZIP1/ZIP2 instructions. This patch fixes bogus diagnostic messages for when
the SVE feature is not specified.
Reviewers: rengolin, craig.topper, olista01, sdardis, stoklund
Reviewed By: olista01, sdardis
Subscribers: fhahn, javed.absar, llvm-commits
Differential Revision: https://reviews.llvm.org/D40362
llvm-svn: 320986
All files and parts of files related to microMIPS4R6 are removed.
When target is microMIPS4R6, errors are printed.
This is LLVM part of patch.
Differential Revision: https://reviews.llvm.org/D35625
llvm-svn: 320350
As part of the unification of the debug format and the MIR format, print
MBB references as '%bb.5'.
The MIR printer prints the IR name of a MBB only for block definitions.
* find . \( -name "*.mir" -o -name "*.cpp" -o -name "*.h" -o -name "*.ll" \) -type f -print0 | xargs -0 sed -i '' -E 's/BB#" << ([a-zA-Z0-9_]+)->getNumber\(\)/" << printMBBReference(*\1)/g'
* find . \( -name "*.mir" -o -name "*.cpp" -o -name "*.h" -o -name "*.ll" \) -type f -print0 | xargs -0 sed -i '' -E 's/BB#" << ([a-zA-Z0-9_]+)\.getNumber\(\)/" << printMBBReference(\1)/g'
* find . \( -name "*.txt" -o -name "*.s" -o -name "*.mir" -o -name "*.cpp" -o -name "*.h" -o -name "*.ll" \) -type f -print0 | xargs -0 sed -i '' -E 's/BB#([0-9]+)/%bb.\1/g'
* grep -nr 'BB#' and fix
Differential Revision: https://reviews.llvm.org/D40422
llvm-svn: 319665
This patch fixes an issue where microMIPS ASE flag is not set
when a function has micromips attribute or when .set micromips
directive is used.
Differential Revision: https://reviews.llvm.org/D40316
llvm-svn: 318948
This adjusts the tests to hopfully pacify the
llvm-clang-x86_64-expensive-checks-win buildbot.
Unlike many other instructions, these instructions have aliases which
take coprocessor registers, gpr register, accumulator (and dsp accumulator)
registers, floating point registers, floating point control registers and
coprocessor 2 data and control operands.
For the moment, these aliases are treated as pseudo instructions which are
expanded into the underlying instruction. As a result, disassembling these
instructions shows the underlying instruction and not the alias.
Reviewers: slthakur, atanasyan
Differential Revision: https://reviews.llvm.org/D35253
llvm-svn: 318207
Correct the definition of 'j' as being unavailable for microMIPS32R6 and
provide the 'b' assembly idiom for codegen purposes for microMIPS32r3.
Provide the necessary 'br' pattern for microMIPS32R6 as it now longer
incorrectly uses the 'j' instruction.
Reviewers: atanasyan
Differential Revision: https://reviews.llvm.org/D39741
llvm-svn: 317801
Previously, the 'movep' instruction was defined for microMIPS32r3 and
shared that definition with microMIPS32R6. 'movep' was re-encoded for
microMIPS32r6, so this patch provides the correct encoding.
Secondly, correct the encoding of the 'rs' and 'rt' operands which have
an instruction specific encoding for the registers those operands accept.
Finally, correct the decoding of the 'dst_regs' operand which was extracting
the relevant field from the instruction, but was actually extracting the
field from the alreadly extracted field.
Reviewers: atanasyan
Differential Revision: https://reviews.llvm.org/D39495
llvm-svn: 317475
Mark all symbols involved with TLS relocations as being TLS symbols.
This resolves PR35140.
Thanks to Alex Crichton for reporting the issue!
Reviewers: atanasyan
Differential Revision: https://reviews.llvm.org/D39591
llvm-svn: 317470
These instructions were previously marked as codegen only preventing
them from being assembled as microMIPS or disassembled.
Reviewers: atanasyan, abeserminji
Differential Revision: https://reviews.llvm.org/D39123
llvm-svn: 316656
Previously these instructions were marked codegen only and had
an under-specified instruction description that did not record the
fcc register.
Reviewers: atanasyan, abeserminji
Differential Revision: https://reviews.llvm.org/D38847
llvm-svn: 315905
Add instruction definitions for FP32 mode for recip.d and rsqrt.d.
Previously these instructions were only defined when targeting the
full 64-bit FPU model but were not guarded properly.
Reviewers: nitesh.jain, atanasyan
Differential Revision: https://reviews.llvm.org/D38400
llvm-svn: 315318
Previously, the parsing of the 'subu $reg, ($reg,) imm' relied on a parser
which also rendered the operand to the instruction. In some cases the
general parser could construct an MCExpr which was not a MCConstantExpr
which MipsAsmParser was expecting.
Address this by altering the special handling to cope with unexpected inputs
and fine-tune the handling of cases where an register name that is not
available in the current ABI is regarded as not a match for the custom parser
but also not as an outright error.
Also enforces the binutils restriction that only constants are accepted.
This partially resolves PR34391.
Thanks to Ed Maste for reporting the issue!
Reviewers: nitesh.jain, arichardson
Differential Revision: https://reviews.llvm.org/D37476
llvm-svn: 315310
Implement .set dspr2 directive with appropriate feature bits. This
directive is a counterpart of -mattr=dspr2 command line option with the
exception that it does not influence elf header flags.
Patch by Milos Stojanovic.
Differential Revision: https://reviews.llvm.org/D38537
llvm-svn: 314994
This patch disables codegen support for branch likely instructions to
address a potential bug. These branches were unselectable as
they had the same patterns as the normal branches but came after them
when ISel was concerned.
The branch likely instructions were marked as having no delay
slots when they have annulling delay slots. The delay slot filler
does not currently handle annulling delay slot branches, so this
would lead to wrong codegen if these branches were generated.
Reviewers: atanasyan, nitesh.jain
Differential Revision: https://reviews.llvm.org/D38169
llvm-svn: 314421
In case of using a "nested" relocation expressions like this
`%hi(%neg(%gp_rel()))`, N32 ABI requires generation of three consecutive
relocations. That differs from the N64 ABI case where all relocations
are packed into the single relocation record.
llvm-svn: 313879
The N32 ABI uses RELA relocation format, do not use 3-in-1 relocation's
encoding, and uses ELFCLASS32. This change passes the `IsN32` flag
to the `MCAsmBackend` to distinguish usage of N32 ABI.
We still do not handle some cases like providing the `-target-abi=o32`
command line option with the `mips64` target triple. That's why
elf_header.s contains some "FIXME" strings. This case will be fixed in
a separate patch.
Differential revision: https://reviews.llvm.org/D37960
llvm-svn: 313873
The other members of the dext family of instructions (dextm, dextu) are
traditionally handled by the assembler selecting the right variant of
'dext' depending on the values of the position and size operands.
When these instructions are disassembled, rather than reporting the
actual instruction, an equivalent aliased form of 'dext' is generated
and is reported. This is to mimic the behaviour of binutils.
Reviewers: slthakur, nitesh.jain, atanasyan
Differential Revision: https://reviews.llvm.org/D34887
llvm-svn: 313276
Traditionally GAS has provided automatic selection between dins, dinsm and
dinsu. Binutils also disassembles all instructions in that family as 'dins'
rather than the actual instruction.
Reviewers: slthakur
Differential Revision: https://reviews.llvm.org/D34877
llvm-svn: 313267
This patch corrects the definition of the DINSM instruction.
Specification for DINSM instruction for Mips64 says that size operand should
be 2 <= size <= 64, but it is defined as uimm5_inssize_plus1 which gives
range of 1 .. 32.
Patch by Aleksandar Beserminji.
Differential Revision: https://reviews.llvm.org/D37683
llvm-svn: 313149
This adjusts the tests to hopfully pacify the llvm-clang-x86_64-expensive-checks-win
buildbot.
Unlike many other instructions, these instructions have aliases which
take coprocessor registers, gpr register, accumulator (and dsp accumulator)
registers, floating point registers, floating point control registers and
coprocessor 2 data and control operands.
For the moment, these aliases are treated as pseudo instructions which are
expanded into the underlying instruction. As a result, disassembling these
instructions shows the underlying instruction and not the alias.
Reviewers: slthakur, atanasyan
Differential Revision: https://reviews.llvm.org/D35253
llvm-svn: 310834
Unlike many other instructions, these instructions have aliases which
take coprocessor registers, gpr register, accumulator (and dsp accumulator)
registers, floating point registers, floating point control registers and
coprocessor 2 data and control operands.
For the moment, these aliases are treated as pseudo instructions which are
expanded into the underlying instruction. As a result, disassembling these
instructions shows the underlying instruction and not the alias.
Reviewers: slthakur, atanasyan
Differential Revision: https://reviews.llvm.org/D35253
The last version of this patch broke one of the expensive checks buildbots,
this version changes the failing test/MC/Mips/mt/invalid.s and other invalid
tests to write the errors to a file and run FileCheck on that, rather than
relying on the 'not llvm-mc ... <%s 2>&1 | Filecheck %s' idiom.
Hopefully this will sarisfy the buildbot.
llvm-svn: 308023
Unlike many other instructions, these instructions have aliases which
take coprocessor registers, gpr register, accumulator (and dsp accumulator)
registers, floating point registers, floating point control registers and
coprocessor 2 data and control operands.
For the moment, these aliases are treated as pseudo instructions which are
expanded into the underlying instruction. As a result, disassembling these
instructions shows the underlying instruction and not the alias.
Reviewers: slthakur, atanasyan
Differential Revision: https://reviews.llvm.org/D35253
llvm-svn: 307836
