Making use of VFP / NEON floating point multiply-accumulate / subtraction is
difficult on current ARM implementations for a few reasons.
1. Even though a single vmla has latency that is one cycle shorter than a pair
of vmul + vadd, a RAW hazard during the first (4? on Cortex-a8) can cause
additional pipeline stall. So it's frequently better to single codegen
vmul + vadd.
2. A vmla folowed by a vmul, vmadd, or vsub causes the second fp instruction to
stall for 4 cycles. We need to schedule them apart.
3. A vmla followed vmla is a special case. Obvious issuing back to back RAW
vmla + vmla is very bad. But this isn't ideal either:
vmul
vadd
vmla
Instead, we want to expand the second vmla:
vmla
vmul
vadd
Even with the 4 cycle vmul stall, the second sequence is still 2 cycles
faster.
Up to now, isel simply avoid codegen'ing fp vmla / vmls. This works well enough
but it isn't the optimial solution. This patch attempts to make it possible to
use vmla / vmls in cases where it is profitable.
A. Add missing isel predicates which cause vmla to be codegen'ed.
B. Make sure the fmul in (fadd (fmul)) has a single use. We don't want to
compute a fmul and a fmla.
C. Add additional isel checks for vmla, avoid cases where vmla is feeding into
fp instructions (except for the #3 exceptional case).
D. Add ARM hazard recognizer to model the vmla / vmls hazards.
E. Add a special pre-regalloc case to expand vmla / vmls when it's likely the
vmla / vmls will trigger one of the special hazards.
Enable these fp vmlx codegen changes for Cortex-A9.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129775 91177308-0d34-0410-b5e6-96231b3b80d8
Add a avoidWriteAfterWrite() target hook to identify register classes that
suffer from write-after-write hazards. For those register classes, try to avoid
writing the same register in two consecutive instructions.
This is currently disabled by default. We should not spill to avoid hazards!
The command line flag -avoid-waw-hazard can be used to enable waw avoidance.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129772 91177308-0d34-0410-b5e6-96231b3b80d8
Ideally, we would match an S-register to its containing D-register, but that
requires arithmetic (divide by 2).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129756 91177308-0d34-0410-b5e6-96231b3b80d8
en-mass for C++ PODs. On my c++ test file, this cuts the fast isel rejects by 10x
and shrinks the generated .s file by 5%
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129755 91177308-0d34-0410-b5e6-96231b3b80d8
when they are a truncate from something else. This eliminates fully half of all the
fastisel rejections on a test c++ file I'm working with, which should make a substantial
improvement for -O0 compile of c++ code.
This fixed rdar://9297003 - fast isel bails out on all functions taking bools
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129752 91177308-0d34-0410-b5e6-96231b3b80d8
Before we would bail out on i1 arguments all together, now we just bail on
non-constant ones. Also, we used to emit extraneous code. e.g. test12 was:
movb $0, %al
movzbl %al, %edi
callq _test12
and test13 was:
movb $0, %al
xorl %edi, %edi
movb %al, 7(%rsp)
callq _test13f
Now we get:
movl $0, %edi
callq _test12
and:
movl $0, %edi
callq _test13f
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129751 91177308-0d34-0410-b5e6-96231b3b80d8
is, it assumes addresses are 64-bit aligned (which should be the more common
case). If the alignment is found not to be aligned, then getOperandLatency()
would adjust the operand latency computation by one to compensate for it.
rdar://9294833
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129742 91177308-0d34-0410-b5e6-96231b3b80d8
small heap-allocated SmallString because it unconditionally forces a malloc.
(Revised version of r129688, with the necessary flush() call.)
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129716 91177308-0d34-0410-b5e6-96231b3b80d8
registers for fast allocation a different way. This has us updating
used registers only when we're using that exact register.
Fixes rdar://9207598
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129711 91177308-0d34-0410-b5e6-96231b3b80d8
the generated FastISel. X86 doesn't need to generate code to match ADD16ri8
since ADD16ri will do just fine. This is a small codesize win in the generated
instruction selector.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129692 91177308-0d34-0410-b5e6-96231b3b80d8
value constraints on them (when defined as ImmLeaf's). This is particularly important
for X86-64, where almost all reg/imm instructions take a i64immSExt32 immediate operand,
which has a value constraint. Before this patch we ended up iseling the examples into
such amazing code as:
movabsq $7, %rax
imulq %rax, %rdi
movq %rdi, %rax
ret
now we produce:
imulq $7, %rdi, %rax
ret
This dramatically shrinks the generated code at -O0 on x86-64.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@129691 91177308-0d34-0410-b5e6-96231b3b80d8
